Panasonic TC-14JR1L Operating Instructions Manual

Contents

11VCR INSTALLATIONYour new TV is supplied with programme position ‘0’ designed specifically to receive an RF signal from a VCR.However, depending on the VCR’s setting you may not receive any picture or sound from the VCR on programme position ‘0’ of the TV. Itwill be necessary to either adjust the RF channel of the VCR or to adjust the tuning of the TV’s programme position ‘0’ or both until the RFoutput channel of the VCR is received.It is intended that this advice is used in conjunction with the instruction books for your ancillary equipment.rear ofVCR--- + To start search for VCR playbackTo return to viewing screenTo store position  To select programme position ‘0’Programme position and current channelare displayed top left of screenAccess the Manual tuning menu asdetailed on page 9.TO TUNE YOUR TV TO THE VCRInsertrecorded tapeand selectplaybackSet TV toprogrammeposition ‘0’VCRAdjusttuningOperationcompletedSee below forinstallation of VCRandSatellite ReceiverTO TUNE YOUR VCR TO THE TVRF CHANNEL ADJUSTNote :Some VCR’s are capable of adjusting theirRF channel via their remote control unit.Manual Tuning: Programme Position---/+ : Start SearchTV/AV : Store.F : Previous MenuN : Exit21 69VCRCH32VCRIf you are going to use a Satellite Receiver and a VCR, it is important, to avoid tuning problems, that they are both tuned to output theirsignals on different channels. For example, if your VCR is tuned to output channel 32, your Satellite Receiver could be set to outputchannel 34. Refer to your Satellite Receiver and VCR instruction books for precise tuning information.