Panasonic TC-L32C22X Operating Instructions Manual

Also see for Viera TC-L32C22X: Operating instructions

12 13Quick StartGuide First Time SetuporTurn the TV On with the POWER buttonor(TV) (Remote)Configure your viewing modeSelect your languageLanguage / Idioma / LangueEnglish Español Français selectOKSelect your viewing mode (Be sure to select “Home use”)Set viewing mode Step 2 of 6Please select your viewing environment.Select “Home Use” when using this TV in yourhome.Home Use Store DemonstrationOKRETURNSelectselectOKPlease confirm your selection (Home Use) before pressing OK button.If you select “Store Demonstration” by mistake in ,confirmation screen will be displayed.NoYou are selecting the store demonstration mode.If you select “Yes”, the picture mode will regularly resetto “Vivid” and a Picture Refresh message will be displayed on thescreen.Yes selectOKSelect “No” and return to previous screen .If you select “Yes”, Screen enters the store demonstration mode.To display the “Set viewing mode” screen again as shown above and select“Home Use”, do one of the following:• Press and hold down the side POWER button for at least five seconds.• Unplug power cord for 30 seconds and plug it again.Noteis not available on - .is not available on .When you have used to turn the TV off, the next time you turn the TV on the“Language” settings will be displayed.If you use any other step other than to turn the TV off, or if you used the EXITbutton to quit before completing the settings, the next time you turn the TV on “Firsttime setup” will not be automatically displayed.• The settings up to that point are saved.• You can reset the settings using “First time setup”. (p. 25)To change the setting (Language, ANT/Cable setup, Input labels, Clock) later, go tothe Menu screen (p. 25)First Time SetupFirst time setup screen is displayed only when the TV is turned on for the first time after the power cord isinserted into a wall outlet and when “Auto power on” (p. 25) is set to “No”.Press to return tothe previous screenAuto channel setup (ANT/Cable setup)Select the connected Antenna in terminalANT/Cable setup Step 3 of 6Cable Antenna Not usedANTENNACable InANTENNACable InSelect “Not used” when viewing TV viaSatellite receiver or Cable box. Note: Select“Cable” when viewing via Cable DTA Box.OKRETURNSelectselectOKNot used: Go to(Label inputs)Select “Not used” when no wire is connected to the “Antenna/Cable” terminal.Typical when a Cable/Satellite box is connected to a TV input.Prevents accidental tuning to an unavailable signal.Select “Start”Auto program Step 4 of 6Start scanning for channels via the TV’sbuilt-in tuner. Select “Skip” when viewing TVchannels via Satellite receiver or Cable box.Start SkipOKRETURNSelectselectOKSkip: Go to(Label inputs)Start scanning the channels(Available channels are automatically set.)Auto programProgressNumber of analog channelsNumber of digital channelsPress RETURN to quit8%100RETURNComplete the Auto program setupCompletion message is displayed when the Auto program scan is successfullycompleted.Auto programAuto program completed.Press OK to continue.Number of analog channelsNumber of digital channels100OKRETURNOKIf there is no availablechannel, return to -(ANT/ Cable setup).“Not used” will be selected.Operation of the EXIT button during “First time setup”Press the button once to display confirmation screen. Press again to closeconfirmation screen.[EXIT confirmation screen]Are you sure you want to exit the First Time Setup?To repeat the First Time Setup, select“First time setup” in the Setup Menu.Yes NoYes Exit “First time setup”No Return to the original screen.