Panasonic TH-103PF10UK Operating Instructions Manual

Also see for TH-103PF10UK - 103" Plasma Panel: Technical guide Service manual Service manual Operating instructions Manual de instrucciones

Contents

Item Effect AdjustmentsSlot PowerOff Auto OnOff: Power is not transmitted to the slot power.Auto: Power is transmitted to the slot power only when main power is on.On: Power is transmitted to the slot power when main power is on or in the standby state.Note: In some cases, power is transmitted to the slot power when main power is on or in the standbystate regardless of the slot power setting.Power OnScreen DelayOff 1 2 3.... 30You can set the power-on delay time of the displays to reduce the power load, when you press toturn on the multiple displays that are set together, for example, on MULTI DISPLAY system.Set each display’s setting individually.Off: The display will be turned on at the same time as is pressed.1 to 30 (sec.) : Set the power-on delay time (second).After pressing , the display will be powered on with time delay depending on this setting.Notes:• During this function is working, the power indicator is blinking green.• This function also works when the power recovers from failure or after plugging off and in again thepower cord.After you unplug and plug the power cord in while the unit is in standby mode and also the power isbeing supplied to a terminal board, the unit will start supplying the power to the board with time delayaccording to the setting.The power indicator lights up red first and it turns orange when the power starts being supplied to theboard.V.Installation Off OnOff: Sets fan to the horizontal installation mode.On: Sets fan to the vertical installation mode.Notes:• This functions when display is turned on.• If the display is installed vertically, the power switch should be located at the bottom.Rotate Off OnOff: Does not rotate the image.On: Rotates the image 180 degrees.Serial SlotSelectSlot1 Slot2 Slot3Selects the slot which communicates serial.Note: The setting of an external command can be set only from the fixed serial terminal. (see page 11)NormalizationWhen both main unit buttons and remote control are disabled due to the “Button lock”, “Remocon User level” or “RemoteID” adjustments, set all the values “Off” so that all the buttons are enabled again.Press the - / button on main unit together with button on the remote control and hold for more than 5 seconds. The“SHIPPING” menu is displayed and the lock is released when it disappears.3/3OptionsOffOffOffV. lnstallationRotateSlot1Serial Slot SelectSlot powerOffPower On Screen Delay47Options Adjustments