31Reduces power consumption1/2PCOFFSTANDBY SAVE OFFPOWER MANAGEMENT OFFAUTO POWER OFF OFFOSD LANGUAGE ENGLISH (US)COMPONENT/RGB-IN SELECTRGBINPUT LABELSIGNALPOWER SAVESET UP1/2PCOFFSTANDBY SAVE OFFPOWER MANAGEMENT OFFAUTO POWER OFF OFFOSD LANGUAGE ENGLISH (US)COMPONENT/RGB-IN SELECTRGBINPUT LABELSIGNALPOWER SAVESET UPPress to select“POWER SAVE”“STANDBY SAVE”“POWER MANAGEMENT”“AUTO POWER OFF”.Press to select “ON” or “OFF”.On OffPress to exit from SET UP.• POWER SAVE: When this function is turned ON, luminous level of the Plasma Display is suppressed, sopower consumption is reduced.• STANDBY SAVE: When this function is turned ON, power consumption of the microcomputer is reduced duringpower supply standby (see page 12, 14-15), so standby power of the set is reduced.• POWER MANAGEMENT: The unit power supply is turned ON or OFF depending on whether or not there is a signalduring PC input mode.This function is enabled when it is turned ON. (Only during input from PC(Mini D-sub)terminal)• AUTO POWER OFF: Equipment power supply is turned OFF when there is no signal.When this is set to On, the power supply of the unit goes Off 10 minutes after the inputsignals stop.This function is effective for input signals except input from PC (Mini D-sub) terminal.Press to select INPUT LABEL.Press to change the INPUT LABEL.Customizing the Input labelsThis function can change the label of the Input signal to be displayed.Select the input signal which you would like to change its label before customizingthe Input labels. (see page 13, 15)Note:While selecting a Input signal through Optional Terminal Board connected to Slot 1, Slot 2 and Slot 3, the Input label willdepend on each Optional Terminal Board.INPUT LABELS for Slot 1, Slot 2, Slot 3 and Mini D-sub:[Slot1 Input] INPUT1/VIDEO1/COMPONENT1/RGB1/DIGITAL1/PC1/DVD1/CATV1/VCR1/STB1[Slot2 Input] INPUT2/VIDEO2/COMPONENT2/RGB2/DIGITAL2/PC2/DVD2/CATV2/VCR2/STB2[Slot3 Input] INPUT3/VIDEO3/COMPONENT3/RGB3/PC3/DVD3/CATV3/VCR3/STB3[PC (Mini D-sub) input] PC/COMPONENT/RGB/DVD/STBNote:“POWER MANAGEMENT” and “AUTO POWER OFF” areeffective during normal viewing (one picture screen) only.123Addition sign “A” “B”Selected Input Composite S VIDEOWhen BNC Dual Video Terminal Board (TY-FB9BD) is used, an “A” or “B” is added at the end of each input label, dependingon the input selected (see below).