Panasonic TH-50PH12L Operating Instructions Manual

Contents

1 2SERIALPC INAUDIOSLOT1 SLOT3PR /CR /R P B/CB/B Y/GAUDIOR LCOMPONENT/RGB INSLOT2VIDEOAUDIOR L AUDIOR LAV INB AS VIDEO12 121210For TH-42PH12L, TH-50PH12LWhen connecting the speakers, be sure to use only the optional accessory speakers.Refer to the speaker’s Installation Manual for details on speaker installation.Connections– Cable xing bandSecure any excess cables with band as required.Note:Make sure that the AC cordis locked on both the left andright sides.Push untilt h e h o o kclicks.2. Pull off.1. Keep theknobpressed.CloseOpen1 Plug the AC cord intothe display unit.Plug the AC cord untilit clicks.2 Fix the AC cord withthe clamper which isattached to the unit.Note:One xing band is supplied with this unit. In case of securing cables at two positions, please purchase it separately.Speakerterminal (R)Speakerterminal (L)Speakers (Optional accessories)Pass the attached cablexing band through the clipas shown in the gure.To secure cables connected to Terminals, wrap the cable xing band around them thenpass the pointed end through the locking block, as shown in the gure.While ensuring there is sufcient slack in cables to minimize stress (especiallyin the power cord), rmly bind all cables with the supplied xing band.From SERIALTerminal onComputer(see page 12)From EXTERNALmonitor terminalon Computer(see page 11)AC cord connection (see page 15)Dual Video Terminals(equivalent of BNCDual Video TerminalBoard (TY-FB9BD))(see page 13)To tighten: To loosen:PullPullPush the catchNote: At factory shipment, Terminal boards are installed in SLOT 2 and SLOT 3.– AC cord xingOptional TerminalBoard Insert Slot(covered)COMPONENT/RGB IN andAudio IN Terminals (equivalentof BNC Component VideoTerminal Board (TY-42TM6A))(see page 14)Unplug the AC cordUnplug the AC cordpressing the twoknobs.Note:When disconnecting the AC cord, beabsolutely sure to disconnect the ACcord plug at the socket outlet rst.