English106Note● Shows leading error codes.Details of the detected errors are as follows.Errorcode Detail of the error1. No USB memory is inserted.2. scenario.dat/filelist.dat cannot be opened.3. There is an error in the contents ofscenario.dat/filelist.dat.4. The play file format is not supported.5. No play file exists.7. There are several identical file definitions.8. The scenario’s play time is over the limit.9. The file definition listed in the scenario isnot in the file list.10. The scenario contains 0 or over 1000 playfiles.11. There are 0 or over 1000 play files.(Single Media Player (Type 1) only)• For error code 1 and 11, only the error code andthe detail of the error are displayed as shownbelow.1No USB memory is inserted.Supplementary noteThe USB memory contents check does not determinewhether or not a play file is playable.If a file cannot be played while Media Player is active,an error message will be displayed.Starting / ending Media PlayerStart1. Insert the USB memory device for Media Playerinto the USB terminal at the bottom of the displayunit.Note● Depending on the type of a USB memory device,it may come in contact with the periphery suchas a back cover, and cannot be attached. Use acommercially sold extension cable, or use a smalltype of a USB memory device connectable to thisunit.USBUSB memoryUSB terminal2. Run a USB memory contents check.3. Change INPUT to [USB].EndingChange INPUT to other than [USB].Resume Play functionAfter Media Player ends, the file to be played back nexttime varies depending on the setting of [USB mediaplayer settings] - [Resume play].When set to [On]:The file played prior to the end of Media Player startsplaying from the beginning.When set to [Off]:Play starts from the beginning of the first file of thescenario.Note● The resume play function is retained until the unit isturned off or the USB memory device is taken out.
