91 2SERIALPC INAUDIOSLOT1 SLOT2 SLOT3VIDEO P R /CR /R PB/C B/B Y/GAUDIOR LCOMPONENT/RGB INAUDIOR L AUDIOR LAV INB AS VIDEO12 12SPEAKERSTerminals (R)SPEAKERSTerminals (L)– Cable fixing bandsSecure any excess cables with bands as required.When connecting the speakers, be sure to use only the optional accessory speakers.Refer to the speaker’s Installation Manual for details on speaker installation.(Example: TH-42PH10UK)Speakers (Optional accessories)Pass the attached cablefixing band through the clipas shown in the figure.To secure cables connected to Terminals, wrap the cable fixing band around them thenpass the pointed end through the locking block, as shown in the figure.While ensuring there is sufficient slack in cables to minimize stress (especiallyin the power cord), fi rmly bind all cables with the supplied fixing band.From SERIALTerminal onComputer(see page 11)From EXTERNALmonitor terminalon Computer(see page 10)AC cord connection (see page 13)Dual Video Terminals(equivalent of BNCDual Video TerminalBoard (TY-FB9BD))(see page 12)To tighten: To loosen:PullPullPush the catchNotes:• At factory shipment, Terminal boards are installed in SLOT 2 and SLOT 3.• TH-37PH10UK has two slots only.– AC cord fixingOptional TerminalBoard Insert Slot(covered)COMPONENT/RGB IN andAudio IN Terminals (equivalentof BNC Component VideoTerminal Board (TY-42TM6A))(see page 12)ConnectionsNote:Make sure that the AC cord is locked on both the left and right sides.Plug the AC cord into the display unit.Plug the AC cord until it clicks.Unplug the AC cordUnplug the AC cordpressing the twoknobs.Note:When disconnecting the AC cord, beabsolutely sure to disconnect the ACcord plug at the socket outlet first.