1 212 12128Connections– Cable fixing bandSecure any excess cables with band as required.Note:Make sure that the AC cordis locked on both the left andright sides.Push untilthe hookclicks.2. Pull off.1. Keep theknobpressed.CloseOpen1 Plug the AC cord intothe display unit.Plug the AC cord untilit clicks.2 Fix the AC cord withthe clamper which isattached to the unit.Note:One fixing band is supplied with this unit. In case of securing cables at two positions, please purchase it separately.Speaker terminal (R, L)When connecting the speakers, be sure to use only the optional accessory speakers.Refer to the speaker’s Installation Manual for details on speaker installation.Speakers (Optional accessories)AC cordconnection(see page 12)Pass the attached cablefixing band through the clipas shown in the figure.To secure cables connected to Terminals, wrap the cable fixing band around themthen pass the pointed end through the locking block, as shown in the figure.While ensuring there is sufficient slack in cables to minimize stress (especiallyin the power cord), fi rmly bind all cables with the supplied fixing band.To tighten: To loosen:PullPullPush the catch– AC cord fixingUnplug the AC cordUnplug the ACcord pressingthe two knobs.Note:When disconnecting the AC cord, beabsolutely sure to disconnect the ACcord plug at the socket outlet first.INPUT1: Video input terminalINPUT2: S Video input terminalINPUT3: Component/RGB Video input terminalsConnect a video device such as VCR or DVD player. (see page 11)From SERIALterminal oncomputer(see page 10)From audio output terminalon external equipmentconnected to INPUT1 to 4(see page 9, 11)INPUT4: PC input terminalFrom EXTERNAL monitorterminal on computer(see page 9)