Panasonic TX-29FX20R Service Manual

Also see for TX-29FX20R: Service manual Service manual

2 Service Hints2.1. Service Position for E-Board1. Remove the back cover.2. Stand the TV set as shown in Fig. 2.3. Remove the A-Board from the TV set by pulling the main board out as shown in Figure 2.Fig. 22.2. Adjustment for White BalancePreparation:1. Receive the white balance pattern and aging should have been performed over 30 minutes.2. Set the picture menu to DYNAMIC NORMAL.3. Degausse the CRT face.4. Fix the CRT colour analyzer receiver unit to CRT face.Adjustment of Low Light.1. Adjustment Sub Bright, so that Y = 6.5 ± 1.0 nit.2. Adjustment R-CUT OFF, so that X = 0.247 ± 0.005 nit.3. Adjustment G-CUT OFF, so that Y = 0.273 ± 0.005 nit.Adjustment of High Light1. Adjustment Sub Bright, so that Y = 150 nit.2. Adjustment R-Drive, so that X = 0.261 ± 0.003 nit.3. Adjustment B-Drive, so that Y = 0.267 ± 0.003 nit.2.3. Adjustment for CRT CUT OFFPreparation:1. Connect the oscilloscope probe to (GREEN CATHODE) on L Board.2. Screen VR min.3. Set the data Sub Bright, Bright.4. In service Mode at “Bright” dac press [5] in factory mode to enter vertical line and adjust by volume down or up button.5. Adjust “Screen VR” to set voltage as in table 1.5TX-29FX20R