- 48 -■ DVB-C1. Enter the frequency with numeric buttons● Normally set Symbol Rate and Service ID to Auto.2. Select Start scan with / and press OK to search■ DVB-T1. Select a channel with / and adjust frequency with / for eachchannel● Set where the level of Signal Quality becomes the maximum.2. Press OK to search■ AnalogueSet Analogue channel manually after Auto Setup.● Set Sound System and Colour System, and then perform this function.Normally set Colour System to Auto.– SC1: PAL B, G, H / SECAM B, G– SC2: PAL I– SC3: PAL D, K / SECAM D, K– F: SECAM L, L’1. Select the channel position with numeric buttons2. Select the channel with Channel Up / Down button3. Search with /4. Select Store with / and press OK to set● Use Fine Tuning to make small adjustments to the tuning of an individualprogramme (affected by weather conditions, etc.).● If a VCR is connected only with the RF cable, select channel position 0.Update Channel ListBy updating the DVB channel list, you can add new channels, delete removed
