- 77 -Note● TV Guide may also be used to set timer programming event.Watching TV Guide Timer Programming● Timer Programming can store up to 15 events.● Timer Programming only works reliably if correct time information isreceived via the signal from the broadcaster or service provider.● For recording using Timer Programming, the TV must be either on or inStandby. For reminders to be displayed, the TV must be on.● No other channels can be selected while the recording of TimerProgramming is in progress.● Recording an encrypted (copy-protected) programme may not be possible.● 2 minutes before the starting time, a reminder message appears if you arewatching TV.– To remove the message and start the programming, press OK.– To cancel the programming, press EXIT.● LED will turn to orange in Standby mode if Timer Programming is set.● Timer Programming reminder messages will remain displayed until one ofthe following occurs:– You press OK to view the programme or EXIT to cancel the reminder.– The timer programming event that the reminder is set for ends.● “!” identifies that two or more timer programming events are overlapped.USB HDD Rec. is given priority over Reminder. As for the overlappedrecording events, the first event starts and finishes as programmed. Thenext event can then start.● The recording of Timer Programming will automatically change thechannel to the programmed channel a few seconds before the startingtime.● The recording of Timer Programming will be performed even if the TV isin REW LIVE TV recording. In this case, REW LIVE TV recording will becancelled.Recording Recording current programme REW LIVE TV● For more information of the USB HDDRecording Technical information
