22EnglishReplicating the settings – Set Up LoaderThe Set Up Loader (separately purchased) replicates the settings of the master set into other units.Selecting the master set settingsSelect the settings of the master set (see pages 9-12).You can replicate the following settings.Terminal Board settingMenu SubmenuTuning (P.9) CH SELECT, SYS SELECT, AUTO TUNE or MANUAL TUNE tuning results, SOUND SYS, COLOUR SYS, SKIPSet up (P.13) TELETEXT, CH COLOUR SET, CHILD LOCK, D.PNR, MPEG NR, COLOUR SYS,3D-COMB, TEXT SELECT, LANGUAGEHotel mode (P.20) Hospitality Mode, Initial INPUT, INPUT Lock, Initial POS, Channel lock, Initial VolumeLevel, Maximum Volume Level, OSD OFF, Button lock, Remote lock, ES Timer, SLEEPDisplay settingMenu SubmenuPicture Picture Mode, Contrast, Brightness, Colour, Tint, Sharpness, White balance, Colour ManagementAdvanced settings(when the setting turns on)Gamma, AGCSound Sound Mode, Bass, Mid, Treble, Balance, SurroundCopy the master set setting to the Set Up LoaderPreparation1. Set up the master set. Refer to the (noted above) for what kind of settings you can copy.2. Turn the unit off only with pressing the unit button (not with the remote control). Subsequently connect the unitwith the Set Up Loader via cable. Be sure that [GREEN] LED (upper right of the Set Up Loader) lights whenconnecting the M3 plug.Set up the master set.Turn the unit off first. Subsequently connect the unit with the Set Up Loadervia cable.Turn the unit on with connecting the Set Up Loader.1Press the terminal board’s remote control buttons within 1 second inaccordance with the order below to enter the UP LOADING Mode.Programme Number Selection UP , DOWN buttons, Direct ProgrammeNumber , , , buttons (as for button, press and hold for 3 seconds).Data copy will be started when OK button is pressed.[UP LOADING]TV -> LOADERPUSH OK KEY[UP LOADING]WRITING DATA ...PROGRESS 5%[UP LOADING]WRITE FAILEDPLEASE TURN OFF[UP LOADING]WRITE COMPLETEDPLEASE TURN OFFProgress is shown on the unit during writing the data to the Set Up Loader.[RED] LED (upper left of the Set Up Loader) blinks for about 5 secondswhen you fail the data copy.If progress does not become 100% and this is displayed, you fail the datacopy. Turn the unit off and repeat the procedure 2 again.You can complete the data copy successfully when this is displayed.Turn the unit off and disconnect the cable.234Notes:• Exclusive remote control is required for the Display’s setting. Refer to the operating instructions for the setting details.• Selected set values of Picture Mode and Audio Mode above will be replicated.