Panasonic TY-FB9TU Operating Instructions Manual

Also see for TY-FB9TU: Service manual Service manual

Panasonic TY-FB9TU Operating Instructions Manual Manual pdf 13 page image

13EnglishReplicating the settings - CLONE BOXThe Clone Box (separately purchased) replicates the settings of the master TV into other TVs.1 Select the settings of the master TV (see pages 9-12).You can replicate the following settings.2 Press [ CH , CH ] or the numbered buttons to select the initialchannel you would like to display at power ON (ex. self-advertisingchannel).3 Press [ VOL , VOL ] to select the volume level which will bethe maximum volume in the HOTEL mode (see page 14).Be sure to set the TV to the normal TV mode before uploading. If not in the normalTV mode, change the mode referring to “Switching between the normal TV modeand the HOTEL mode” (see page 14).Preparation• Connect the master TV display to the AC outlet.• Connect the Clone Box to the MATE terminal on the tuner board.1 Turn the master TV display on.2 Turn the Clone Box on.The red and green LEDs on the Clone Box flash.3 Hold down [ALT] button and press [LEARN] button on the CloneBox.• The red LED flashes during uploading.• The green LED lights for approx. 2 seconds when uploading is completed.• After uploading, the master will be automatically switched into the HOTEL mode.4 Turn the main power of the display and the Clone Box off.Selecting the master TV settingsUploading the master TV’s settings into the Clone Box (LEARN)POWERASPECTR-TUNERECALLACTIONCHCHVOL VOLINPUTTV/VIDEOMUTESAPMenu Submenu Menu SubmenuPICTURE PIC MODE AUDIO BASSCOLOR TREBLETINT CHANNELS PRESET CAPTIONBRIGHTNESS MANUAL CAPTIONPICTURE INPUT LABELSHARPNESS SET UP AUTO PROGRAMCOLOR TEMP MANUAL PROGRAMENERGY MGMT1. Insert a slender tool about 3/4 inch (ex. a paper clip) into[AMS] hole on the Clone Box to switch the TV to the normalTV mode.The green LED lights for approx. 2 seconds.2. Press [TEST] button on the Clone Box.• The red and green LED flash alternately during checking.• The green LED lights for approx. 2 seconds when the settingsreplicated in the Clone Box correspond to the master TV settings.If the red LED does not light, upload the settings again.1. Turn the Clone Box on.2. Hold down [ALT] button and press [TEST]button on the Clone Box.• The red and green LEDs flash alternatelyduring checking.• The green LED lights for approx. 2 secondswhen the battery has enough remainingpower. If the LEDs do not light, replace thebattery to new one (use a 9-volt battery).To check the settings uploaded into the Clone Box To check the Clone Box’s battery