Panasonic TY-SP37P4-S Operating Instructions Manual

Also see for TY-SP37P4-K: Operating instructions Operating instructions

Contents

3 English• Adjust so that there is a uniform clearancebetween the Wide Plasma Display and thespeakers, and then securely tighten the bracketmounting screws.• Secure the top and bottom mounting brackets bytightening the bracket mounting screws.• Secure the left speaker in the same way.4. Secure the speakers inplace.• Insert the hooks on the top and bottom mountingbrackets simultaneously into the slots at the rearof the Wide Plasma Display, and then lower thespeaker into place.• Attach the left speaker in the same way.3. Attach the speakers to theWide Plasma Display.Bracket mountingscrewRear of Wide Plasma DisplayHook Rear of Wide Plasma DisplaySlotSlotFor 50" Display1. Push down the lever.For 37", 42" Display2. Insertthe cable.3. Return the lever toits normal position.1. Press down on the lever.2. Insertthe cable.3. Release the lever.1. Push down the lever.3. Return the lever to itsnormal position.2. Insertthe cable.• After preparing the ends of the speaker cables, connect them as shown.• Connect the speaker cable for the left speaker in the same way.• The red cable is for the (+) side and the black cable is for the (-) side. Do not connect the cables to the wrong sides.When these speakers are attached to the plasma display, they will not form a straight line but rather so thatthey slightly face inward, to produce stable sounds.5. Connect the speaker cables.Preparing the ends of thespeaker cablesWhile twisting1. If connecting to an external amplifier which exceeds therated input for the speakers, lower the amplifier volume toprotect the speakers from damage. If any problems occurwith speaker operation, disconnect the mains lead of theamplifier and consult a qualified service technician.2. Do not place the speakers in the following places:• Places which are exposed to direct sunlight• Near heaters or other heat sources• Places with high humidity3. This set is equipped with magnetic resistant speakers butbe careful not to place them near the CRT TV as it maycause color patches.4. To clean the speakers, wipe them with a soft cloth. If theyare extremely dirty, wipe them with a cloth which has beensoaked in a small amount of household detergent, and thenwipe the dry with a separate cloth.• Do not use solvents such as alcohol or thinner.• If using chemically-treated cloths, follow the instructionson the cloth packaging.5. Remove the dust on the speaker net using a duster or avacuum cleaner at low power. Since the net is made ofcloth, pushing too hard on it may damage the net.Notes on use