Panasonic Toughbook CF-50 Series Manual

Also see for Touchbook CF-50 Series: Operating instructions Operating instructions Operating instructions Reference manual Operating instructions

57List of Error Codes02F5: DMA Test FailedServerBIOS2 test error: Cannot write to extended DMA (Direct Memory Access) registers.02F6: Software NMI FailedServerBIOS2 test error: Cannot generate software NMI (Non-Maskable Interrupt).02F7: Fail - Safe Timer NMI FailedServerBIOS2 test error: Fail-Safe Timer takes too long.device address ConflictAddress conflict for specifieddevice.Allocation Error for:deviceRun ISA or EISA Configuration Utility to resolve resource conflict for the specifieddevice.Failing Bits :nnnnThe hex numbernnnn is a map of the bits at the RAM address which failed the memory test. Each 1 (one) in the map indicatesa failed bit. See error 230,231 or 232 for offset address of the failure in System, Extended or Shadow memory.Invalid System Configuration DataProblem with NVRAM (CMOS) data.I/O device IRQ conflictI/O device IRQ conflict error.Operating System not foundOperating system cannot be located on either drive A: or drive C:. Enter Setup and see if fixed disk and drive A: are properlyidentified.Parity Check 1nnnnParity error found in the system bus. BIOS attempts to locate the address and display it on the screen. If it cannot locate theaddress, it displays ????. Parity is a method for checking errors in binary data. A parity error indicates that some data has beencorrupted.Parity Check 2nnnnParity error found in the I/O bus. BIOS attempts to locate the address and display it on the screen. If it cannot locate the address,it displays ????.Press to resume, to SetupDisplayed after any recoverable error message. Press to start the boot process or to enter a Setup and change thesettings. Write down and follow the information shown on the screen.