59Wireless LANNOTEz You can use the following procedure instead of turning on wireless LAN in the Wireless Switch Utility.A Click (Start) - [Control Panel] - [Adjust commonly used mobility settings].B Click [Turn wireless on] in [Wireless Network].• When [Turn wireless off] is displayed, the wireless network is already on.• If you cannot select [Turn wireless on], the wireless switch is turned off.Setting the wireless LAN access pointPreparationFollow the instruction manual of the wireless LAN access point to make settings for the access point to recognize the com-puter.1 Turn the wireless LAN on.2 Click or on the notification area and click [Connect to a network].If your computer is already connected to another network, click [Connect / Disconnect]. The [Connect to a network]screen appears.3 Click and select an access point, and click [Connect].4 Input the key you set for the access point to recognize the computer, and click [Connect].Wait for the computer to connect to the wireless LAN access point.When [Successfully connected to XXXX] is displayed, the wireless LAN setting is complete.z [Save this network] : Add a check mark to save the password, settings, etc.z [Start this connection automatically] : Add a check mark so the computer automatically detects the access pointand connects to the Internet.5 Click [Close].NOTEz The settings depend on the network environment. For further information, ask the system administrator or the personin charge of the network.z To connect to the access point for connection in the stealth mode (ANY access denied), perform the steps below.A Click or on the notification area and click [Network and Sharing Center]-[Manage wireless networks].B Click [Add] and select [Manually create a network profile].C Add a check mark for [Connect even if the network is not broadcasting] and set the access point.