Panasonic U-16GE2E5 Test Run Manual

Also see for S-250WX2E5: Manual Technical data

Contents

Panasonic U-16GE2E5 Test Run Manual Manual pdf 49 page image

II - 41e Checking mode changesFor these checks select a mode that is different from the mode in which the performance checks werecarried out.n Press the HOME (S004) key to display the menu item num-ber. “ ” (Figure 27)o Next, press the UP (S005) or DOWN (S006) key to selectmenu item number “ ” (Figure 28)p After “ ” has been displayed, display the test run/forced setting display “  ”. While in test run/forcedsetting display press the SET (S007) key. (Figure 29)q When the SET (S007) key is pressed in the test run/forcedsetting, the display changes. Use the UP (S005) or DOWN(S006) key to select the forced cooling test run mode “  ” or forced heating test run mode “  ”. (Figure 30)• When in heating mode change to cooling mode• When in cooling mode change to heating moder When in the forced test run setting mode, press the SET(S007) key for longer than 1 second and the mode changes tocooling (heating) test run. At this stage check the following.• The thick tubes are hot when heating mode is selected (donot touch the tubes with your bare hand)• The thick tubes are cold when cooling mode is selected.f Stopping the test runn Press the HOME (S004) key to display the menu item num-ber. “ ” (Figure 27)o Next, press the UP (S005) or DOWN (S006) key to selectmenu item number “ ” (Figure 28)p After “ ” has been displayed, display test run/forcedsetting “  ”. In test run/forced setting display press theSET (S007) key. (Figure 29)q When the SET (S007) key is pressed when the status is testrun/forced setting display, the display changes. Use the UP(S005) or DOWN (S006) key to select the forced cooling testrun mode “  ”, or the forced heating test run mode “  ”. Then press the SET (S007) key for longer than 1second. The TEST/WARNING indicator (red LED (D052)goes off, and the state returns to forced setting selection.(Figure 30)g If as a result of the above a fault has been detected, carry out aninvestigation, correction or improvement in accordance with the separate “Service and Technical Reference Manu-al Type M1 Series, Troubleshooting.”(2) Completion of operationsCheck again that there are no omissions in the test run check list record, or that there are no malfunctioning items.Figure 27Figure 28Figure 29Figure 30