Panasonic U-250PE1E8 Operating Instructions Manual

Also see for S-200PE2E5: Technical data & service manual Operating instructions Technical data & service manual Technical data & service manual Operating instructions

Contents

Panasonic U-250PE1E8 Operating Instructions Manual Manual pdf 5 page image

5ENGLISHNames of PartsINDOOR UNITAir outlet sideduct flange(2 locations)Air intakeside ductflange (rear)Water drainElectricalcomponent boxOptionalHigh-spec WiredRemote ControllerModel No.CZ-RTC3Read the operating instructions included with the Remote Controller.Timer Remote ControllerModel No.CZ-RTC2Wireless Remote ControllerModel No.CZ-RWSK2Model No.CZ-RWSC3OperationNOTE For details, refer to the Operating Instructions attached to the optional RemoteController.Operation Mechanism Heating performance Since this air conditioner utilizes outside air for heating,its heating performance deteriorates as outside tempera-ture decreases.(Due to heat pump system)→In that case, use another heating appliance. Defrosting This appliance may start defrosting operation to meltfrost formed in the outdoor unit.1Defrosting starts: The indoor unit fan stops (or thespeed becomes extremely slow).→ “ ” (STANDBY) appears.2Heating operation resumes after severalminutes: The indoor unit fan remains stopped (orit will run at a very slow speed) until the indoor heatexchanger coil warms up sufficiently.→ “ ” (STANDBY) is shown.3Defrosting is complete: The indoor unit fan startsoperation.→ “ ” (STANDBY) disappears. ‘‘DRY’’ operation Once the room temperature reaches the level that wasset, the outdoor unit repeats the cycle of turning on andoff automatically. When the outdoor unit is turned off, the indoor unit fanwill stop, too.(To prevent the humidity in the room from rising again) When the room temperature is more likely to reach thelevel that was set, the fan speed is set to ‘‘breeze’’ (lightwind) automatically. ‘‘DRY’’ operation is not possible if the outdoortemperature is 15 °C or less. Should the power failure occurs while theunit is runningWhen the unit automatically resumes operation aftertemporary power failure, it uses the same settings beforethe power was cut off. Operation mode Select from: HEAT /DRY /COOL /FAN /AUTO . Fan speed High /Medium /Low /Auto