Panasonic UB-5310 Installation Manual

Also see for Panaboard UB-5310: Brochure & specs Operating instructions Operating instructions Specification sheet Operating instructions

Contents

Panasonic UB-5310 Installation Manual Manual pdf 11 page image

11EnglishElectronic Board Operations CheckAfter assembling the electronic board, perform the procedures presented in the following table to make sure itfunctions properly.StepPoints to CheckSymptom Solutions1 Turn on the power switch. “ ” flashes after “ ” lights up. (Normal operation)(If not) Check power cord andcables.(See step 23 on page 10and step 18 on page 9.)2 Open the printer door and load thecopy paper, then close the printer door.• loading the copy paper procedure(refer to the Operating Instructionspage 10)“ ” lights up after the copy paperis fed and automatically cut.(Normal operation)(If not) Check the condition ofprinter door or copypaper roll.3 Press . Screen is fed. (Normal operation)The screen film surface is not fedsmoothly.Contact the store ordealer from which theunit was purchased.There are strange noises.4 Use the accessory marker to drawa large filling the entirecopyable area of the screen filmsurface.• Copying area (refer to theOperating Instructions page 7)Press twice.Press .“ ” lights up and three copiesare made.(Normal operation)Three copies are not made. Contact the store ordealer from which theunit was purchased.The entire readable area is notprinted.There are strange noises orpaper jams during the copyingprocess.5 Press to move the screen filmsurface.Write letters, etc. with the marker.Press once.Press .The Contrast indicator light isturned on and copy is made.(Normal operation)The Contrast indicator light isnot turned on.Contact the store ordealer from which theunit was purchased.The image is not copied properly.There are strange markings onthe copy sheet (e.g., stripes orlines).6 Press once. The Contrast indicator light isnot turned off.Contact the store ordealer from which theunit was purchased.7 Press . Two screens are not copiedproperly.Contact the store ordealer from which theunit was purchased.