15First Time SetuporTurn the TV on with the POWER buttonor(Remote)(TV)Setup the following items● Select your language● Select your viewing mode (Be sure to select “Home Use”)If you select “Store Demonstration” by mistake, confirmation screenwill be displayed.To display the “Set viewing mode” screen again and select “HomeUse”, perform “Reset to defaults” in the “Setup” menu.● ANT/Cable setupSelect signal type (Over-the-Air/Cable service).Select Auto Program and start scanning.Scanning starts.NoteIf at the end of the scanning no channels are found, then check:1. Antenna’s position – or2. Availability of Cable serviceCable, Satellite or Fiber services with a box are typically connected tothe TV’s A/V inputs, preferably HDMI, for best HD picture. In such acase, the channel scanning is not needed (set “ANT in” to “Cable”).Complete First time setupCompletion screen is displayed.You can repeat the First time setup• Press MENU --> Setup --> Reset to defaultsTo watch TV via a Cable box, Satellite receiver, or any other source(DVD, DVR, gaming device, etc.), press the INPUT button and selectthe appropriate input.The setup screen will be displayed only when the TV is turned on for the first time and afterthe power cord is inserted into a wall outlet.Getting started First Time SetupIdentifying Controls