Panasonic VIERA TH-L32DT30A Operating Instructions Manual

Also see for VIERA TH-L32DT30A: Operating instructions

Viewing 3D images27Available range for the 3D EyewearIf the 3D Eyewear is placed outside the available area for about 5 minutes, the 3D Eyewear will beturned off automatically.: Available area to use the 3D Eyewear35°35°Approx.3.2 mApprox.3.2 mApprox.3.2 m 20°20°Approx.3.2 mView from the top View from the sideNote• The range may be shortened depending on the obstacles between the infrared sensors on the TV andthe 3D Eyewear, the dirt of the infrared sensors or the surrounding environment.• If you do not look toward the TV screen for a while when viewing 3D images, the 3D Eyewear may beturned off automatically even if in the available area.To view the 3D imagesYou can watch 3D images in the following cases:• When a 3D image supporting Blu-ray Disc is played on a 3D image supporting player/recorderconnected using a HDMI cable to a 3D image supporting television.• 3D image supported broadcast (program)• 3D Photo, 3D Movie taken by LUMIX/Camcorder.• 2D→3D (Converts 2D images into 3D) “Change the view 3D ↔ 2D” (p. 28)To view the contents or programmes1 Set the power switch to “ON”.(The indicator lamp will light for approximately 2 seconds, then flash once approximately every2 seconds.)2 Put on the 3D Eyewear3 Watch the 3D imagesWhen the HDMI receives information in which 3D mode is detected, 3D images are automaticallydisplayed according to the signal.If the 3D images are not displayed correctly or the images cause discomfort, the images can beadjusted by [3D Mode Selection] or [3D Settings].• Change the view 3D ↔ 2D, 3D settings (p. 28, 29)■ After Use1 Set the 3D Eyewear power switch to “OFF”.(The 3D Eyewear indicator lamp turns off, and the power turns off.)2 After using the 3D Eyewear, store it in the case provided.