7Connections● External equipment and cables shown are not supplied with this TV.● Ensure that the unit is disconnected from the mains socket before attaching or disconnecting any leads.● Check the type of terminals and cable plugs are correct when connecting.● Always use a fully wired HDMI cable.● Keep the TV away from electronic equipment (video equipment, etc.) or equipment with an infrared sensor.Otherwise, distortion of image / sound may occur or operation of other equipment may be interfered.● Also read the manual of the equipment being connected.Terminals67243151 SD Card slot2 USB 1 - 3 port3 HDMI1 - 3 (p. 8, 9)4 DIGITAL AUDIO OUT5 AV (COMPONENT / VIDEO)(p. 9)6 Aerial terminal(see below)7 ETHERNET (p. 8)Basic connectionsMains lead and aerial■ Digital TV, Analogue TVAC 220-240 V50 / 60 HzMains lead(supplied)AerialRF cable■ Mains leadMake sure thatthe mains lead issecurely fixedTo remove from the TV:tabsPress both tabs and pull onmains connector to releasePush until both sidetabs click● Keep RF (aerial) cable away from the mains lead to avoid and minimise mains interference pickup.● Do not place the RF cable under the TV.● An aerial, correct cable (75 Ω coaxial) and correct terminating plug are required to obtain optimum quality picture andsound.● If a communal aerial system is used, you may require the correct connection cable and plug between the wall aerialsocket and the TV.● Your local Television Service Centre or dealer may be able to assist you in obtaining the correct aerial system for yourparticular area and the accessories required.● Any matters regarding aerial installation, upgrading of existing systems or accessories required, and the costsincurred, are the responsibility of you, the customer.