Panasonic VL-SW250BX Installation Manual

Also see for VL-MW250BX: Operating instructions Installation guide

Contents

Before installationTo avoid malfunction or communication disturbances, do not install either the door station or themain monitor station in the following locations:– Places where vibration or any other kind of impact occurs.– Places where echoing is frequent.– Places near a high concentration of dust, hydrogen sulfide, ammonia, sulfur, or noxious fumes.– Within 2 m of a TV, microwave, personal computer, air conditioner or any other electrical device.Installation position of the door station and camera rangeN Views when the camera is facing forwards at 0° (default).LExample: Installation height is 1450 mm (standard position).Side view Top viewImage range:960 mm500 mm87°1450 mm1810 mmCenter ofthe doorstation 66° 650 mmImagerange1160 mm500 mmThe camera angle can be adjusted using the camera angle control lever on the rear of the doorstation (step 3, “Installing the door station”), so that the image range can be changed.Center ofthe doorstation1690 mm1100 mm66°710 mm500 mm980 mmImagerangeImage range:1080 mm810 mm500 mm87°270 mmN Side view when the camera is installedlower than the standard position, andfacing upwards at 15°.LExample: Installation height is 1100 mm.N Top view when the camera is facingleft or right at 15° *1.LExample: Camera angle faces left 15°.*1 If the camera points 15° upwards, the left or right angle is less than 7°.Note:LThe measurements and angles are for reference purposes and may vary depending on theenvironment.LIf a strong light is shining on the door station, the visitor’s face may not be distinguishable.Do not place the door station in the following locations.– Where most of the background is the sky.– Where the background is a white wall, and direct sunlight will reflect off it.– Where direct sunlight will shine on the door station.LDo not place the door station in the locations where echoing occurs, causing the unit to beepfrequently.LMake sure the rear of the door station is not subject to water.Standard installation position of the main monitor stationPlace the main monitor station in a location that your eyes are the same height as the center of thedisplay.If a position of installation for the main monitor station is specifiedInstall the mounting bracket to one of the following positions.82.5 mm49 mm51.9 mmPosition of installation for the main monitor stationNote:LThis unit is using an electric wave frequency of 2.4 GHz. Read “For best performance” in theOperating Instructions.LIn areas surrounded by a high electrical field, disturbances may occur in the main monitorstation’s image or sound.LBe sure to install the main monitor station more than 5 m away from the door station.LDo not place any objects within 20 cm of the main monitor station. This may causecommunication errors or malfunction.LDo not install the main monitor station inside a wall.LDo not install the main monitor station in places where it will be affected by extremely high-frequency radio waves (near broadcasting antennas etc.). This may cause the display to flickeror an interrupting noise to occur.If you change to the main monitor station from chime, bell or buzzerExisting wires (e.g. chime, bell or buzzer) may connect to power supplies (AC 100 – 240 V or 24 V).If you connect the main monitor station through such existing wires, electric shock or unit damagemay occur. Contact the dealer where you purchased.Installation GuideLPlease read this Installation Guide before installing the unit and save for future reference.LPlease read this Installation Guide carefully, and install the unit safely and correctly byfollowing the instructions. Panasonic assumes no responsibility for injuries or propertydamage resulting from failures arising out of improper installation or operation inconsistentwith both the Installation Guide and Operating Instructions.LPlease confirm the wiring schematic diagram in this Installation Guide when you increasean optional equipment .For door station and main monitor stationFor your safetyTo prevent severe injury and loss of life/property, read this section carefully before using theunit to ensure proper and safe operation of your unit.WARNINGLTo reduce the risk of electric shock, do not disassemble this unit. Refer servicing to anauthorized service center when service is required. Opening or removing covers mayexpose you to dangerous voltages or other risks. Incorrect reassembly can cause electricshock when the unit is subsequently used.LDo not make any wiring connections when the power supply is turned on.LNever install wiring during a lightning storm.LDo not overload power outlets and extension cords. This can result in the risk of fire orelectric shock.LDo not install the main monitor station in the following places:– Places where the main monitor station may be splashed with water or chemicals.– Places where there is a high concentration of dust, or high humidity.LWhen existing chime wires are used, it is possible that they contain AC voltage. Electricshock or unit damage could result. Contact an authorized service center.CAUTIONLInstall the unit securely adhering to the instructions in this guide to prevent it from falling offthe wall. Avoid installing onto low-strength walls, such as gypsum board, ALC (autoclavedlightweight concrete), concrete block, or veneer (less than 18 mm thick) walls.LIf the wiring is outdoors, use a protection tube or a surge protector.LIf the wiring is underground, do not make any connections underground.LIf the wiring is underground, use a protection tube.ModelNameWireless VideoIntercom System Main MonitorModel No. VL-SW250BX VL-MW250BX VL-V566BX VL-MW250BXIncluded accessories for installationLMounting bracket ............1LAttached to the rear of the mainmonitor station.LWood screws ..................2(4 mm × 16 mm)LWood screws ..................2(3.8 mm × 20 mm)LAttached to the bag the door stationis in.For the door station For the main monitor station1-62, 4-chome, Minoshima, Hakata-ku, Fukuoka 812-8531, Japan© Panasonic System Networks Co., Ltd. 2010PNQW2395ZA SV0910SN0VL-V566BX is described as “Doorstation” and VL-MW250BX is describedas “Main monitor station” in this guide.

/ 3

Related manuals for Panasonic VL-MW250BX