Panasonic VariCam LT Operating Manual

Also see for AU-V35LT1G: Operating instructions

Contents

Panasonic VariCam LT Operating Manual Manual pdf 202 page image

– 202 –Chapter 12 Maintenance — Warning systemWarning systemIf an error is detected immediately after the camera is turned on or during operation, the viewfinder and warning lamp indicate the error. Deal with theerror by following the indications.Cases indicated by error codesError code Viewfinder statusdisplay Description Behavior and cause[E-30] [TURN POWER OFF]An error occurred in the camera built-in memorybecause the P2 card being accessed was ejected.f Warning lamp flashes four times per second.Alarm will sound four times in one second.f Cannot operate.f Follow the message to turn off the power once andturn on the power again.f Ensure that there is no error in the clips on the ejectedcard, and restore the clips as necessary.[E-31] [TURN POWER OFF]System mode error occurred.f Warning lamp flashes four times per second.Alarm will sound four times in one second.f Cannot operate.f Follow the message to turn off the power once, turnon the power again, and check that there is no errordisplay.[E-35] [SYSTEM ERROR]Codec control error occurred.f Warning lamp flashes four times per second.Alarm will sound four times in one second.f The operation stops.f Contact your dealer.[E-36] [SYSTEM ERROR]P2 system error occurred.f Warning lamp flashes four times per second.Alarm will sound four times in one second.f The operation stops.f Contact your dealer.[E-37] [SYSTEM ERROR]P2CS microcomputer error occurred.f Warning lamp flashes four times per second.Alarm will sound four times in one second.f The operation stops.f Contact your dealer.[E-39] [SYSTEM ERROR]Video initialization error occurred.f Warning lamp flashes four times per second.Alarm will sound four times in one second.f The operation stops.f Contact your dealer.[E-64] [SYSTEM ERROR](or no display)Reference signal error occurred.f Warning lamp flashes four times per second.Alarm will sound four times in one second.f The operation stops.f Contact your dealer.Cases indicated by error messagesDuring recording/playbackViewfinder status display Description Behavior and cause[AUTH NG CARD]The CPS authentication of the memory card has failed.The memory card that has failed CPS authenticationcannot be recorded or played back.f The current operation will continue.[BACKUP BATT EMPTY]Displays any reduced voltage detected on the backupbattery in the internal clock when the power is turnedon.f The current operation will continue.f Charge the built-in battery.f Set the time.[CARD ERROR]Displayed when an data error caused by the P2 cardoccurs during recording.Displayed after recording stops until the next operation.Also displayed for three seconds during playback whena P2 card error causes playback to stop.f If the error occurs during recording, the warninglamp flashes four times per second for approx. threeseconds after recording stops.Alarm will sound four times in one second.f Warning lamp does not light up when an error occursduring playback.f The operation will stop.f After it stops, the P2 card on which the error occurredis write-protected. Replace the P2 card of the slotwhere the error occurred.[DIR NG CARD] The directory position is not correct.f The current operation will continue.f Make a card backup immediately and format the cardto use it again.[FAN STOPPED] Displayed when the fan motor is stopped.f The current operation will continue.f If the fan has stopped with error, stop using thecamera immediately and consult your dealer.f If the fan has stopped, temperature of the camerawill rise. Therefore, do not use the camera for a longperiod of time.[HIGH TEMPERATURE] The temperature inside the camera is higher than that ofthe normal conditions.f Power is automatically turned off after approximatelyfive seconds after abnormal temeperature is detected.f Turn on the power again and check recording andplayback operations. If the problem persists, consultyour dealer.