23Advanced PIP1235Press to display the Setup menu.46Notes:• If “INPUT lock” in Options menu is set to other than “Off”, MULTI PIP function isn’t available.• Sound output is from the picture which is selected in Audio OUT (PIP) (see page 26).• In 2 screen display, the same input mode cannot be selected for the main picture and sub picture.• The main picture and sub picture are processed by different circuits, resulting in a slight difference in the clarity of thepictures. There may also be a difference in the picture quality of the sub picture depending on the type of signals displayedon the main picture and depending on the 2-picture display mode.• Due to the small dimensions of the sub pictures, these sub pictures cannot be shown in detail.• Computer screen picture is displayed in a simplified format, and it may not be possible to discern details on them satisfactorily.• Following combinations of two analog signals cannot be displayed simultaneously;Component - Component, Component - PC (RGB), PC (RGB) - Component, PC (RGB) - PC (RGB)• Refer to each board's operating instruction for DVI, SDI, HDMI's corresponding signals.Press repeatedly.Each time pressing thisbutton main pictureand sub picture will bedisplayed as above.Note:To use , , , buttons for the screen operations, follow the procedures in the previous page.7(When Advanced PIP is On)One screen Advanced PIPMain screenSub screen 1 2 36 5 4OptionsOnWeekly Command TimerOnscreen displayOffInitial INPUTInitial VOL level1/3OffOff00Maximum VOL levelOffINPUT lockOffButton lockOffRemocon User levelOffAdvanced PIPPress to select “OSD Language”.Press to select Advanced PIP.Press to adjust the menu.Off : Sets normal two screen display mode(see page 22).On : Sets Advanced PIP mode.Press to confirm.Press and hold until the Options menu is displayed.Press to exit fromOptions menu.