Panasonic Viera TH-37PH10 Operating Instructions Manual

Contents

10Pin No. Signal Name Pin No. Signal Name Pin No. Signal Name1 R (PR /CR ) 6 GND (Ground) 11 NC (not connected)2 G (Y) 7 GND (Ground) 12 SDA3 B (PB/CB) 8 GND (Ground) 13 HD/SYNC4 NC (not connected) 9 NC (not connected) 14 VD5 GND (Ground) 10 GND (Ground) 15 SCLAUDIOPC INTH-42PS9167839451015 14 13 12 112(Example: TH-42PH10UK)TH-42PH10UK, TH-50PH10UK,TH-58PH10UK16 7 8394 51015141312112TH-37PH10UKConnectionsPC Input Terminals connectionNotes:• Due to space limitations, occasionally you may have trouble connecting Mini D-sub 15P cable with ferrite core to PCinput Terminal.• Computer signals which can be input are those with a horizontal scanning frequency of 15 to 110 kHz and vertical scanningfrequency of 48 to 120 Hz. (However, the image will not be displayed properly if the signals exceed 1,200 lines.)• The display resolution is a maximum of 768 × 720 dots (TH-37PH10UK), 768 × 768 dots (TH-42PH10UK), 1,024 × 768dots (TH-50PH10UK, TH-58PH10UK) when the aspect mode is set to “NORMAL”, and 1,024 × 720 dots (TH-37PH10UK),1,024 × 768 dots (TH-42PH10UK), 1,366 × 768 dots (TH-50PH10UK, TH-58PH10UK) when the aspect mode is setto “FULL”. If the display resolution exceeds these maximums, it may not be possible to show fine detail with sufficientclarity.• The PC input terminals are DDC2B-compatible. If the computer being connected is not DDC2B-compatible, you will needto make setting changes to the computer at the time of connection.• Some PC models cannot be connected to the set.• There is no need to use an adapter for computers with DOS/V compatible Mini D-sub 15P terminal.• The computer shown in the illustration is for example purposes only.• Additional equipment and cables shown are not supplied with this set.• Do not set the horizontal and vertical scanning frequencies for PC signals which are above or below the specifiedfrequency range.• Component Input is possible with the pin 1, 2, 3 of the D-sub 15P Connector.• Change the “COMPONENT/RGB-IN SELECT” setting in the “SET UP” menu to “COMPONENT”(when component connection) or “RGB” (when RGB signal connection). (see page 36)Signal Names for Mini D-sub 15P ConnectorPin Layout for PC InputTerminalCOMPUTERConversion adapter(if necessary) Mini D-sub 15pRGBPC cableStereo plugAudioConnect a cable which matchesthe audio output terminal on the computer.