Panasonic Viera TH-42PZ850AZ Operating Instructions Manual

CH Display / Receive Programme CH Display / Receive ProgrammeCH 1 ~ CH 11 CH 74 ~ CH 78CH 21 ~ CH 70 CH 80 ~ CH 120Audio Signal STEREO MAIN I SUB II MONOMode Indicator I IIType of broadcast Regular broadcast(Standard Audio)Regular + NICAM MONO I(MAIN I ) NICAM STEREO NICAM DUAL MONO(MAIN I / SUB II )Mode Indicator No Indicator I I IIType of broadcast Regular broadcast(Standard Audio)BILINGUAL or DUAL MONO:MAIN I / SUB II STEREOMode Indicator No Indicator I II46Technical InformationProgramme Allocation (Analogue TV mode)Rating (Digital TV mode)Rating Meaning- Not classifiedG General ProgrammesPGR Parental Guidance RecommendedAO Adults OnlyStereo / Bilingual Sound Selection (Analogue TV mode)Note• If the stereo signal is poor or the receiving conditions are not optimum or if STEREO:MONO automatic switchingoccurs, it is recommended you switch from STEREO to MONO.• Even when the contents of the receiving signal undergo changes, selection mode is kept intact.• When the receiving conditions deteriorate, listening will be easier if the mode is set to the MONO position.• DUAL, also known as DUAL MONO or as BILINGUAL is not currently transmitted in some countries.When you receive the stereo / bilingual sound system, sound output modes can be selected by “MPX” in theSound Menu (p. 26).NICAM .......Used in New Zealand, Singapore, Hong Kong etc.A2(German) .......Used in Australia, Malaysia etc.Note• During downloading, do not turn Off the TV or touch any buttons.(The TV is automatically activated after downloading is completed.)• When the TV is switched to standby, there will be a clicking sound after a short delay. Similar clicking sounds will alsooccur at 3:00 AM and 5:00 AM when “Auto update Search in Standby” (p. 32) is set to “On”. These sounds are normal.Update system software to ensure that you have latest version software.If there is an update available, a notification banner is displayed when the service has the update information.• To download new software, press “OK” Downloading (approx. 20 mins.)If you choose not to download, press “EXIT”.■ To update automaticallySet “Auto Update Search in Standby” to “On” (p. 32)If there is a new version software being broadcast, the TV will download this automatically.• The automatic updating sequence is carried out at 3:00 AM and 5:00 AM every morning under the following condition.Standby (TV turned Off with the remote control)■ To update manuallyPerform “System Update Search Now” (p. 32)If there is an update available, a notification banner is displayed.• To download new software, press “OK” Downloading (approx. 20 mins.)If you choose not to download, press “EXIT”.Updating the software system (Digital TV mode)