20Advanced21MENU EXITMain menuPicture menuSetup menuSound menuOff timerCh colour setChild lockSide panelSD card LEDSetup menuOnPower save OffHighTuning menu AccessOffOffTeletext TOPHDMI settingOwner IDSkipAuto tuningManual tuningSound systemColour systemFine tuningSys selectTuning menu5.5MHzAutoOffAustraliaManual tuningSearch down/upStoreProgramme down/upReturnExit1Manual tuning (Front panel)- , + : SearchTV / AV : Move cursorSTR : To storeF : To exit5. 5MHz15. 5MHzSTR F -STR F - / + / TV / AVMENUEditing and Setting ChannelsSetmanuallyManualtuningThe current channel settings can be changed according to your needs and reception conditions.For Auto tuning, see p. 10.■ To exitEXIT• Editing and Setting ChannelsDisplay the menu12 Select "Setup menu"3 Select "Tuning menu"4 Select the function5 Set EditSoundsystemEditColoursystemSmalladjustmentFinetuningSkip theprogrammeSkipSelect the programme numberand search through the channel(Press repeatedly until "Tuning mode" appears)or (Access Tuning menu)(Press repeatedly until "Auto tuning" is reached)or (Searching channels)For Auto tuning, using thebuttons on the TV("Tuning mode" on p. 7)■ To return to TVIf the sound is weak or distorted, change the sound system used for a programme channel. (5.5MHz / 6.5MHz)Select the channel you want to adjust Set this functionIf the image is strange, change the colour system to the correct transmission signal being received. (Auto / PAL /NTSC 4.43 / NTSC 3.58)Select the channel you want to adjust Set this function• Normally, select "Auto"For the small adjustments to the tuning of an individual channel (useful for example when weather conditions areaffecting reception quality of a programme)Select the channel you want to adjust Set this function• To cancel Fine tuning, tune again by Manual tuningFor the skip programme numbers which have no tuning datas• This function is only effective when pressing the Programme number up or down button either on the TV or onthe remote control.Select the channel you want to skip Set "Skip" to "On"StoreProgrammenumberChannelRepeatandNote• If a VCR isconnected withonly the RFcable, selectprogrammenumber "0".• The programmenumber blinks.To freely change settings after Auto setup(Press repeatedly until "Tuning mode" appears)or (Access Tuning menu)(Press repeatedly until "Manual tuning" is reached)or (Access Manual tuning)(Programme, Channel (not displayed), Sound system)or (Change programme, Start searching channels, Change sound system)(Store)- (Repeat)For Manual tuning, using the buttons on the TV("Tuning mode" on p. 7)■ To return to TVProgramme number(flash)ChannelSound system(flash)• Not available when Child lockin Setup menu is set (p. 18).• Not available when Child lock in Setup menu is set(p. 18).accessselectaccessselectnextselectsearchselect