Auto Tuning14Auto TuningSearch and store TV channels automatically.● These steps are not necessary if the setup has been completed by your local dealer.● Please complete connections (p. 11 - 13) and settings (if necessary) of the connected equipment before starting AutoTuning. For details of settings for the connected equipment, read the manual of the equipment.1 Plug the TV into mains socket and switch on● Takes a few seconds to be displayed.● If the red LED shows on the TV, press the Standby On / Off switch on theremote control.2 Select your languageOSD LanguageEnglishselectset3 Select your countryCountryThailand VietnamSaudi ArabiaUnited Arab EmiratesMalaysiaIndiaOthersKuwaitIndonesiaSingaporeselectset4 Select your areaChannel PlanAsia/W.EuropeNZ/IndonesiaChinaCIS/E.EuropeCATV/OtherHong Kongselectaccess● When selecting [CATV/Other], press theOK button, and then select the ChannelPlan from Indian CATV, South Africa,American System, American CATV orJapan CATV.Auto Tuning starts● Auto Tuning will start to search for TV channels and store them.The stored channels and sorted channel order vary depending on the area,broadcasting system and conditions of signal reception.CH 421 120Auto TuningScan5 Setup the network connectionSetup the network connection to enable the network service functions such as VIERAConnect, etc. (p. 17, 46).● Please note that this TV does not support wireless public access points.● Ensure the network connections (p. 13) and network environment are completedbefore starting setup.Select the network typeNetwork SetupSelect Wired or WirelessWired Wireless Set later[Wired] “Wired connection” (p. 13)[Wireless] “Wireless connection”(p. 13)selectaccess● To setup later on or skip this stepSelect [Set later] orTH-L32_42_47E5KMT_EN.indd 14TH-L32_42_47E5KMT_EN.indd 14 3/20/2012 6:48:01 PM3/20/2012 6:48:01 PM