Panasonic Viera TH-L32U20Z Operating Instructions Manual

Technical57 FAQsProblem ActionsScreenChaotic image, noisy● Change the setting of “P-NR” in the Picture Menu (to removenoise) (p. 24).● Check nearby electrical products (car, motorcycle,fluorescent lamp).No image can be displayed ● Is “Colour” or “Contrast” in the Picture Menu set to theminimum? (p. 24)Blurry or distorted image(no sound or low volume) ● Reset channels (p. 30, 31).Unusual image is displayed ● Turn off the TV with Mains power On / Off switch, then turnit on again.“Shop” appears on screenat switch on● “Shop” was selected in “Auto Tuning” (p. 12).● Reset all settings in “Shipping Condition” (p 34), then select“Home” in “Auto Tuning” (p 12).Sound No sound is produced ● Is “Sound Mute” active? (p. 10)● Is the volume set to the minimum?Sound level is lowor sound is distorted ● Sound signal reception may be deteriorated.● Set “MPX” in the Sound Menu to “Mono” (p. 25).HDMI Sound is unusual● Set the sound setting of the connected equipment to “2chL.PCM”.● Check the “HDMI1 / 2 / 3 Input” setting in the Sound Menu(p. 26).● If digital sound connection has a problem, select analoguesound connection (p. 51).Pictures from externalequipment are unusualwhen the equipment isconnected via HDMI● Is the HDMI cable connected properly? (p. 43, 48, 49)● Turn Off the TV and equipment, then turn them On again.● Check an input signal from the equipment (p. 52).● Use an equipment compliant with EIA/CEA-861/861B.Digital TVDue to the digital reception technologies involved, quality of the Digital TV signals may berelatively low in some cases, despite good reception of Analogue TV channels.Unable to receive signalswith a high-performanceaerialTVVCR(Individual aerial)(Individual aerial)AerialInputterminalSplitterAerial OutputAerial InputAerial Output● Install an aerial individually for the TV and VCR(or use a splitter).Interference orfrozen / disappearingimage in Digital TV● Check “Digital TV Signal Condition” (p. 30).If “Signal Quality” or “Signal Strength” are displayed inred, check aerial. If problem persists, consult your localPanasonic dealer.● Turn the TV off with the Mains power On / Off switch, thenturn it On again.OtherTV goes into Standbymode● Auto power standby function is activated.● The TV enters Standby mode about 30 mins. after analoguebroadcasting ends.The remote control doesnot work or is intermittent● Are the batteries installed correctly? (p. 3)● Has the TV been switched On?● Point the remote control directly at the front of the TV (withinabout 7 m and a 30 degree angle of the front of the TV).● Situate the TV away from sunshine or other sources ofbright light not to shine on the TV’s remote control signalreceiver.

/ 60

Related manuals for Panasonic Viera TH-L32U20Z