Panasonic Viera TH-P42UT30D Operating Instructions Manual

Also see for Viera TH-P42UT30D: Service manual

Auto Tuning163 ■ [Wireless]Select the connection typeConnection TypePlease select network connection type.WPS(Push button)Search for access point confirmselect • If your access point supports WPS (Pushbutton), then select this option. If not,select [Search for access point].■ [Search for access point]Access points found automatically are listed.Available Access PointsNo.1 Access Point A 11n(2.4GHz)2 Access Point B 11n(5GHz)3 Access Point C 11n(5GHz)SSID Wireless type Encrypt Reception1 Select your desired access pointaccessselect • To search access points again Y• For the information of thehighlighted access pointINFO• To set manually (p. 63) REncryption Key SettingConnection will be made with the following settings:-SSID : Access Point AAuthentication type : WPA-PSKEncryption type : TKIPPlease input the encryption key.Encryption key2 Access the encryption key input mode• If the selected access point is not encrypted, the confirmationscreen will be displayed. It is recommended to select theencrypted access point.A B C D E F G H I J K L M NU V W X Y Z 0 1 2 3 4 5 6a b c d e f g h i j k l m nu v w x y z ( ) + - . * _O P Q R S T7 8 9 ! : #o p q r s tAccess Point SettingsEncryption key 3 Enter the encryption key of the access point(Set characters one by one)selectsetStore RETURN• You can set characters by using numeric buttons.Access Point SettingsEncryption key is set to:-XXXXXXXXSelect ‘Yes’ to confirm.Select ‘No’ to change.Yes No4 Select [Yes]setselect• To re-enter the encryption key, select [No].• If the connection has failed, check the encryption key, settingsand positions of your access point. And then, follow the onscreen instructions.■ [WPS(Push button)]1) Please press the ‘WPS’ button on the accesspoint until its light flashes.2) When the light is flashing select ‘Connect’ onTV.If you are unsure, please check the instructionmanual of the access point.WPS(Push button)1) Please press the ‘WPS’ button on the accesspoint until its light flashes.2) When the light is flashing select ‘Connect’ on TV.If you are unsure, please check the instructionmanual of the access point.ConnectPress the WPS button on the access point until the light flashes.And then, press the OK button to connect the Wireless LANAdaptor and the access point.• Ensure that your access point supports WPS for this method.• WPS: Wi-Fi Protected Setup™Perform the connection test after the access point setting is finishedCheck access point connection.Check acquired IP address.Check for devices using same IP address.Check gateway connection.Check server connection.Connection Test : succeededThe test is successful and the TV is connectedto the network.: failedCheck the settings and connections, and thenselect [Retry].• To set manually, select [Manual] and set each item.For details (p. 63)4 Complete the network connection(Press twice)