Panasonic Viera TX-L32E30B Operating Instructions Manual

Contents

FAQs | On screen messages102Problem ActionsOtherThe remote controldoes not work or isintermittent• Are the batteries installed correctly? (p. 7)• Has the TV been switched On?• The batteries may be running low. Replace them.• Point the remote control directly at the front of the TV (within about 7 m and a 30degree angle of the front of the TV).• Situate the TV so that sunshine or other sources of bright light do not shine on the TV’sremote control signal receiver.Parts of the TV becomehot • Temperature rises of parts of the front, top and rear panels will not pose any problems interms of performance or quality of the TV.The LCD panel movesslightly when it ispushed with a fingerClattered sound mightbe heard• There is some flexibility around the panel to prevent damage to the panel.• The panel might move slightly when it is pushed with a finger, and clattered soundmight be heard. This is not a malfunction.Overcurrent errormessage appears• The connected USB device might cause this error. Remove the device and turn the TVOff with Mains power On / Off switch, then turn it On again.• Check if foreign objects are inside the USB port.An error messageappears • Follow the message’s instructions.• If the problem persists, contact your local Panasonic dealer or the authorized Service Centre.On screen messagesMessage Meaning / ActionAll contents will be lost.Are you sure to delete this device? • Once you format the USB HDD, all the recorded programme will be erased.All tuning data will be erased • [Shipping Condition] will erase all tuning data (p. 49)Are you sure ? • Confirm correct operation.Are you sure you want to deletethis timer ?Press OK to delete timer.Press RETURN to return.• Confirm correct operation.Bad signal • The signal is weak. Check the aerial is plugged in properly. It may be necessary tohave an aerial installer check the signal and aerial alignment.• Reset channels. (p. 40)Child Lock is active!Press OK to enter PIN. • The selected channel is locked in Child Lock (p. 47). You must enter the PIN numberbefore the channel will be displayed.External (USB-HDD) RecordingDue to Start • This message will appear 2 minutes before timer programming event for external(USB HDD) recording due to start.Feature not available. • It is not possible to record from COMPONENT or HDMI. Connect the recorder to theTV using a fully wired SCART cable for recording from the TV tuner.• Confirm Q-Link or VIERA Link settings (p. 81 - 84)Feature not available.Press OK to view how it works. • The selected feature on VIERA TOOLS is not available. Press the OK button to viewthe demonstration to explain how to use it.Found new software version ∗∗∗.Press OK to start update (maytake over 40 mins) or press EXITto ignore and you can updatewhen TV is in standby• There is a new software available.Invalid operation - Please checksettings and connections. • Check the Q-Link or VIERA Link connection and setting (p. 81 - 84)Invalid system time. Please exit ! • Cannot get the time information and cannot edit Timer Programming screen.Check the connection of the RF cable.Invalid system time, TimerProgramming will not work.Please press TV button onremote control and check timedisplay on Banner• Cannot get the time information. If there is no time displayed on the Informationbanner, check the connection of the RF cable.Max. number of timers alreadyset ! • The maximum number of timer programming events is 15.