Tuning and Editing Channels34Set Analogue channel manually [Analogue Manual Tuning]Set Analogue channel manually after Automatic Channel Search.Example: AntennaAnalogue Manual TuningSearching channelsScan up Scan downStart Frequency (MHz) 48.001 Enter the frequency to start scanning[Scan up]: Scans ascendingly from the enteredfrequency to higher frequencies[Scan down]: Scans descendingly from the enteredfrequency to lower frequencies2 Select the scanning methodselectaccessChecks the DVB-C / DVB-T signal conditionDVB-C DVB-TThese barsshow themaximumsignal value ofthe selectedchannel.9691DVB-C Signal ConditionFrequency (KHz)Modulation 256QAMSignal LevelSymbol Rate(Ksym/s)Bit Error RateSignal Condition32200068750.00E-069691DVB-T Signal ConditionSignal LevelChannelBit Error RateSignal Condition68750.00E-069691Set DVB channel manually [Manual Tuning]Normally use [Automatic Channel Search] or [Scan] to retune DVB channels.If tuning has not been done completely or for adjusting the direction of the aerial, use this function.All channels found will be added to the Channel List.DVB-CDVB-C Manual TuningCableScanFrequency (KHz)Modulation AutoSignal LevelSymbol Rate(Ksym/s)Signal Condition30600068750%001 Enter the frequency2scanDVB-TDVB-T Manual TuningAntennaScanChannelSignal LevelSignal Condition20%00select channelscanList favourite DVB channels [Favourites Edit], Skip unwanted channels [Skip]Create your favourite channel lists from various broadcasters.1 Select a channel to list ( : Encrypted channel)Favourites Edit1 Analogue3 Digital2 Analogue4 Digitalselect[Add] / [Remove]: [Add]: [Remove] Skip unwanted channels [Skip]You can hide unwanted channels.The hidden channels cannot be displayed except in this function. Use this function to skip unwanted channels.Select a channel and reveal / hideSkip1 Analogue3 Digital2 Analogue4 Digitalaccessselect : Hide (skip): RevealTo change page (page up) To change page (page down) To select To exit(red) (green) (yellow) (blue)