17First time Auto SetupAutomatically sets up the TV and searches for available TV channels when the TV is turned on for the first time.● These steps are not necessary if the setup has been completed by your local dealer.● Please complete connections (p. 8 - 13) and settings (if necessary) of the connected equipment before starting AutoSetup. For details of settings for the connected equipment, read the manual of the equipment.1 Plug the TV into mains socket and turn power on● Takes a few seconds to be displayed.2 Select the following itemsSet up each item by following the on-screen instructions.Select [Home]Select [Home] viewing environment to use in your home environment.● [Shop] is for shop display.● To change viewing environment later on, you will need to initialise all settings by accessing Shipping Condition.Set up the network connectionSelect your countrySelect your region● Auto Setup screen varies depending on the country and the signal mode you select.● [Satellite Antenna Setup]Ensure the satellite connections are completed (p. 9) and select the tuner mode ([Dual Tuner] / [Single Tuner]).Register the VIERA Touch Pad Controller to this TV.Select [Pairing] and follow the on-screen instructions to use the touch pad controller (supplied).● To register later on or detailed settings [VIERA Touch Pad Controller] (Setup Menu)3 Select the type of [Home Screen]The demonstration to explain how to use [my Home Screen] is displayed. Confirm the demonstration byfollowing the on-screen instructions, and then select the desired [Home Screen].Example: [Home Screen Selection] Example: [TV Home Screen]● [my Home Screen] is the start-up screen when the TV is turned on or the HOME button is pressed.Auto Setup is now complete and your TV is ready for viewing.If tuning has failed, check the connection of the network, RF cable, and then follow the on-screen instructions.Note● The TV will automatically go into Standby mode when no operation is performed for 4 hours if [Auto Standby] in theTimer Menu is set to [On].● The TV will automatically go into Standby mode when no signal is received and no operation is performed for10 minutes if [No signal Power off] in the Timer Menu is set to [On].● To retune all channels [Auto Setup] in [Tuning Menu] (Setup Menu)● To initialise all settings [Shipping Condition] in [System Menu] (Setup Menu)