Panasonic Viera TX-L42WT50B Operating Instructions Manual

Also see for Viera TX-L42WT50B: Service manual

Panasonic Viera TX-L42WT50B Operating Instructions Manual Manual pdf 99 page image

Link Functions (Q-Link / VIERA Link)99Q-LinkPreparations Connect the DVD Recorder / VCR with the following logos:“Q-Link”, “NEXTVIEWLINK”, “DATA LOGIC (a trademark of Metz Corporation)”, “Easy Link (a trademark of PhilipsCorporation)”, “Megalogic (a trademark of Grundig Corporation)”, “SMARTLINK (a trademark of Sony Corporation)” Q-Link connection (p. 97) Use fully wired SCART cable. Set up the DVD Recorder / VCR. Read the manual of the recorder. Q-Link terminal setup in the Setup Menu [AV1 out] (p. 49) Download Analogue channel setting “Analogue channel download” (see below)Features availableAnalogue channel downloadAnalogue channel settings can be downloaded to a recorder with an analogue tuner (where Analogue is stillbroadcast). Digital channel settings are not downloaded. To download the Analogue channel settings[Q-Link Download] (p. 49), [Auto Setup] (p. 17, 57)Direct TV Recording - What you see is What you recordRecords the current programme in DVD Recorder / VCR immediately. (When USB HDD / SD Card for recording isconnected in DVB mode, [One Touch Recording] starts.) Confirm the code of the remote control to “73” (p. 35). Available conditions:Picture source Mode Recording fromAnalogue TV TV monitor outAV Recorder’s tunerfreesat, DVB, Other Sat. / Satellite(USB HDD / SD Card for recording is not connected) TV TV monitor outAV (watching recorder’s tuner) AV Recorder’s tunerAV (watching recorder’s external input) AV Recorder’s external inputAV (watching TV’s external input) AV TV monitor out When Direct TV Recording is performed, the recorder is automatically turned on if it is in Standby mode. You can change channel or turn the TV off while the recorder is recording from its own tuner. Changing channel is not available while the recorder is recording from the TV tuner. To stop recordingUnlock the tunerTuner LockedPress EXIT to unlock and stop recordingPower on link and Easy playbackWhen DVD Recorder / VCR starts playback or direct navigator / function menu for the equipment are activated, theTV is turned on and input mode is switched automatically so that you can view the content. (Only when the TV is inStandby mode.)Power off linkWhen TV is set to Standby mode, the recorder is also automatically set to Standby. (Only when the videocassette ordisc is not active.) This function works even if the TV enters Standby mode automatically by auto power standby function.Note Some recorders are not applicable. Read the manual of the recorder.