Panasonic Viera TX-P42G30E Operating Instructions Manual

Also see for TX-P42G30E: Operating instructions Service manual

Contents

Auto SetupQuick Start Guide166 [WPS(Push button)]1. Press the WPS button on the access point until the light flashes2. Connect the Wireless LAN Adaptor and the access point1) Please press the ‘WPS’ button on the accesspoint until its light flashes.2) When the light is flashing select ‘Connect’ onTV.If you are unsure, please check the instructionmanual of the access point.WPS(Push button)Connect• Ensure that your access point supports WPS for this setup.• WPS : Wi-Fi Protected Setup™• If the connection has failed, check the settings and positions of youraccess point. And then, follow the on screen instructions.3. After the access point setting is finished, perform the connection testCheck access point connection.Check acquired IP address.Check for devices using same IP address.Check gateway connection.Check server connection.Connection Test : succeededThe test is successful and the TV is connected to thenetwork.: failedCheck the settings and connections. And then select[Retry].• To set manually, select [Manual] and set each item. Fordetails (p. 74)4. Go to the next step 7(Press twice)7 Select [Home]Select [Home] viewing environment to use in your home environment.Please select your viewing environment.Home Shopsetselect■ [Shop] viewing environment (for shop display only)[Shop] viewing environment is the demonstration mode to explain main features of this TV.Select [Home] viewing environment to use in your home environment.• You can return to viewing environment selection screen at the stage of Shop confirmation screen and AutomaticDemo Off / On selection screen.1 Return to viewing environment selectionscreen2 Select [Home]Please select your viewing environment.Home ShopsetselectShopYou have selected shop mode BACK/RETURNAutomatic DemoOff OnTo change viewing environment later on, you will need to initialise all settings by accessing Shipping Condition.[Shipping Condition] (p. 51)Auto Setup is now complete and your TV is ready for viewing.If tuning has failed, check the connection of the RF cable, and then, follow the on screen instructions.Note• To check channel list at-a-glance “Using TV Guide” (p. 22)• To edit or hide (skip) channels “Tuning and Editing Channels” (p. 40 - 44)• To retune all channels [Auto Setup] (p. 38, 39)• To add the available TV mode later [Add TV Signal] (p. 35, 36)• To initialise all settings [Shipping Condition] (p. 51)If you connect the Wireless LAN Adaptor later on, the confirmation screen will bedisplayed for the setup. Wireless LAN adaptor connected, do you want toset it up?No - ExitCurrent network type : WirelessNoWireless LAN adaptor connectionYes• To setup the wireless connection (p. 75 - 77)