6611.2 Outdoor UnitAttached accessories Optional Accessory11.2.1 Select the Best Location If an awning is built over the unit to prevent direct sunlight or rain, be careful that heat radiation from thecondenser is not obstructed. Avoid installations in areas where the ambient temperature may drop below -20°C. Keep the spaces indicated by arrows from wall, ceiling, fence or other obstacles. Do not place any obstacles which may cause a short circuit of the discharged air. If outdoor unit installed near sea, region with high content of sulphur or oily location (e.g. machinery oil, etc), itlifespan maybe shorten. When installing the product in a place where it willbe affected by typhoon or strong wind such aswind blowing between buildings, including therooftop of a building and a place where there is nobuilding in surroundings, fix the product with anoverturn prevention wire, etc. (Overturn preventionfitting model number: K-KYZP15C) (For UD07*E5*and UD09*E5* only) If piping length is over 10 m, additional refrigerant should be added as shown in the table.Model Piping size Rated Length(m)Max. Elevation(m)Min. PipingLength (m)Max. PipingLength (m)AdditionalRefrigerant (g/m)Gas LiquidUD03*E5* andUD05*E5* ø12.7mm (1/2") ø6.35mm (1/4") 5 5 3 15 20UD07*E5* andUD09*E5* ø15.88mm (5/8") ø6.35mm (1/4") 5 20 3 30 30Example: For UD03*E5*If piping length is 15m, the quantity of additional refrigerant should be 100g. [(15-10)m x 20 g/m = 100g]11.2.2 Install the Outdoor UnitInstallation Diagram11.2.2.1 It is advisable to avoid more than 2 blockage directions. For better ventilation & multiple-outdoor installation,please consult authorized dealer/specialist. This illustration is for explanation purposes only.No. Accessories part Qty. No. Accessories part Qty.1Drain elbow1 3Banding strap(For UD07*E5* andUD09*E5* only)32Rubber cap7 or 8(Depend onModel)4Protective bushing(For UD07*E5* andUD09*E5* only)2No. Accessories part Qty.5Base Pan HeaterCZ-NE2P (For UD03*E5* and UD05*E5* only)CZ-NE3P (For UD07*E5* and UD09*E5* only) 1• It is strongly recommended to install a Base Pan Heater(optional) if the outdoor unit is install in cold climate area.Refer the Base Pan Heater (optional) installation instructionfor details of installation.• Applicable Piping Kit (For UD07*E5* and UD09*E5* only)CZ-52F5,7,10BP100mmor more100mmor more1000mmor more300mmor moreVinyl tape (Wide)SaddleIndoor unit/Outdoor unitconnecting cable (4-COREWIRE/1.5 mm 2 )Type designation 60245 IEC57 or heavier cableø6.35mm (1/4")Liquid refrigerant pipingø12.7mm (1/2")Gas refrigerant pipingVinyl tape(Wide)SaddleIndoor unit/Outdoor unitconnecting cable (4-CORE WIRE/2.5 mm 2 )Type designation 60245 IEC 57 orheavier cableø15.88mm (5/8")Gas refrigerant pipingø6.35mm (1/4")Liquid refrigerant piping100mmor more1000mmor more100mmor more300mmor more [ ]Check that thecables do not touchthe compressor, etc.*5E*90DUdna*5E*70DUroF*5E*50DUdna*5E*30DUroF