Panasonic WH-MDF06D3E5 Operating Instructions Manual

Also see for WH-MDF06D3E5: Operating instructions

Contents

Panasonic WH-MDF06D3E5 Operating Instructions Manual Manual pdf 6 page image

6BASIC OPERATIONOFF / ONTO TURN ON OR OFF THE UNIT• When unit is ON, operation LED is lit and the actualtemperature for water outlet and outdoor ambient areshown on the remote control display.MODETO SELECT OPERATION MODEHEAT HEAT +TANK TANK• HEAT MODE- To turn ON or OFF the panel/floor heating operation.- In this mode, the mono bloc unit will provide heatingcapacity to the system.• HEAT + TANK MODE- In this mode, the mono bloc unit will provide heatingcapacity to the sanitary tank and the system.- This operation is not used when the sanitary watertank is not installed.• TANK MODE- To turn ON or OFF the sanitary tank operation.- In this mode, the mono bloc unit will provide heatingcapacity to the sanitary tank.QUIETTO ENJOY QUIET ENVIRONMENT• This operation reduces mono bloc unit noise. In thiscondition, it may cause decrease in heating capacity.HEATER TO ENABLE THE BACKUPHEATER• The backup heater provides extra heating capacityduring cold outdoor temperature and only can operatedat heat mode operation when he was enabled bypushing this button.• The backup heater will automatically turn ON when thesetting conditions is fulfilled.• To disabled the Heater operation manually, press therespective button again.STATUSSEARCHCHECKSYSTEM STATUS CHECK MODE1.Press CHECKfor 5 seconds to enter STATUS mode.2.Press or to check the Water InletTemperature, Tank Temperature, Compressor RunningFrequency or Error History.• Press CANCELto exit STATUS mode.• Once STATUS mode is entered, “STATUS”indicator is ON.• STATUS mode cannot be activated when the“SETTING” indicator is ON.• It is strongly recommended to contact the nearestauthorized dealer to change the water temperature range.• Using the remote control could set the temperaturerange for water outlet temperature and outdoor ambienttemperature.SYSTEM SETTING MODESETSELECTCANCELSETTINGTIMER OUTDOORHEATSETTINGSTATUSSERVICEBOOSTERDEFROSTQUIETTANKWATER OUTLETCHEATEROPERATIONFORCEHEATERACTUALONOperation Mode Temperature displaySETTING indicatorParameter *1. Press SETfor 5 seconds to enter “SETTING” mode.“SETTING” indicator is ON.2. Press or to choose a parameter.3. After selecting the desired parameter, press SELECTto enterthe parameter.4. Press or to set the desired temperature.5. Press SETagain to confirm the setting.• Repeat steps 2 to 5 to set other parameters.OperationMode Parameter * DescriptionHEAT Low outdoor ambient set temperature(-15°C ~ 15°C).HEAT High outdoor ambient set temperature(-15°C ~ 15°C).HEAT Water outlet set temperature at lowoutdoor ambient temperature(25°C ~ 55°C).HEAT Water outlet set temperature at highoutdoor ambient temperature(25°C ~ 55°C).Water TemperatureOutdoor TemperatureHEAT OFF Set temperature for turning OFF heatingoperation (5°C ~ 35°C).HEATER ONOutdoor ambient set temperature forturning ON heater operation(-15°C ~ 20°C).TANK Sanitary tank set temperature(40°C ~ 75°C).WATER TEMPERATURE THERMO SHIFT SETTING1. Press SETwithin 5 seconds.• Repeat steps 3 to 5 to set the desired shift temperature(-5°C ~ 5°C).Notes:• Press CANCELor wait 30 seconds to exit “SETTING” mode.• The setting temperature will be stored in the system onceconfirm.• “SETTING” mode cannot be activated when the“SERVICE” and “STATUS” indicator is ON.ADVANCE OPERATION

/ 9

Related manuals for Panasonic WH-MDF06D3E5