Panasonic WH-MDF09C3E8 Service Manual

Also see for WH-MDF09C3E8: Design handbook Installation manual Installation manual Operating instructions Operating instructions

Contents

Panasonic WH-MDF09C3E8 Service Manual Manual pdf 42 page image

4211.4 Connect The Cord And Cable To Mono Bloc Unit(REFER TO WIRING DIAGRAM AT UNIT FOR DETAIL)1. An isolating device must be connected to the power supply cable (Disconnecting means). Isolating device (Disconnecting means) should have minimum 3.0 mm contact gap. Connect the approved polychloroprene sheathed power supply 1 cord (5 x min 1.5 mm 2) and power supply 2cord (3 x min 1.5 mm 2) and power supply 3 cord (5 x min 1.5 mm 2), type designation 60245 IEC 57 or heaviercord to the RCCB, and to the other end of the cord to isolating device (Disconnecting means).2. To avoid the cable and cord being damaged by sharp edges, the cable and cord must be passed through abushing (located at the right hand side of the mono bloc unit) before being connected to the terminal block. Thebushing must be used and must not be removed.3. Secure the cable onto the control board with the holder (clamper).