Panasonic WJ-HD88 Operating Instructions Manual

Also see for WJ-HD88: Brochure & specs Network operating instructions

41RS485 setup (RS485 SETUP)Refer to the step (7) in 2.5.Data port setup (DATA PORT SETUP)The settings relating to the serial data communication canbe configured on "DATA PORT SETUP" of "COMMUNICA-TION SETUP" on the "WJ-HD88 SETUP MENU".(1) Press the [MENU] button. The "WJ-HD88 SETUP MENU"will be displayed.(2) Move the cursor onto "COMMUNICATION SETUP" andpress the [SET] button.The "COMMUNICATION SETUP" menu will be dis-played.(3) Move the cursor onto "DATA PORT SETUP" and pressthe [SET] button.The "DATA PORT SETUP" menu will be displayed.(4) Configure the following setup items.• "Unit Address (System)"A unit address (System) is a unique number assigningto PS·Data devices. The addresses must be unique toidentify system devices when connecting multipledevices compatible with PS·Data.Numbers, "001"-"099", are to be assigned as the unitaddresses to the system devices.• "Baud Rate"Select the communication speed for data transmissionwith a connected device from the following.2 400/4 800/9 600/19 200/38 400 bps• "Data Bit"It is impossible to change the value for this setting.8 (bit)• "Parity"Select a method to check a transmission error at com-munication from the following."None": No parity check"Even": Even parity"Odd": Odd parity• "Stop Bit"Select a stop bit from the following.1 bit/2 bit• "Retry Timing"Select a retransmission interval for when data receptionis not confirmed from the following.OFF/100 ms/200 ms/400 ms/1 000 ms• "Alarm Data"Select a method to inform the connected controller ofan event occurrence from the following."Off": Does not function."0s": Informs the controller every time an event isdetected."1s/5s": Informs the controller when a specified timehas passed after detecting an event.• "Channel No."It is possible to assign a number to each camera chan-nel to operate cameras using the controller compatiblewith PS·Data.Do the following to assign numbers to the camera chan-nels.(1) Move the cursor onto "Channel No." and press the[SET] button.The "Channel No." menu will be displayed.COMMUNICATION SETUPNETWORK SETUPRS485 SETUPDATA PORT SETUPWJ-HD88 SETUP MENUSYSTEM MANAGEMENTSEARCHREC&EVENT SETUPPTZ SETUPCAMERA SETUPCOMMUNICATION SETUPREPORTUSER INFORMATIONDATA MANAGEMENTDATA PORT SETUP001Unit Address (System)9600Baud Rate8Data BitNoneParity1Stop BitOffRetry Timing1sAlarm DataSetChannel No.OK Cancel