■ User interface on the operation windowoqiw e r tyuq [Control] button: Search and play recorded images,switch the camera channels, etc.w [Cam. Select] button: Select the camera channel fromwhich images are to be displayed.e [Setup] button: Configure the settings of the recorder.r Status display area: The status of the recorder such asthe recording status, playback status, etc. will be displayed.t Current time display area: The current time will be dis-played.y Image display area: Live images/recorded images will bedisplayed.u Playback point operation area: Designate a point to beplayed or play the latest recorded image.i [HDD] tab: Control playback operation.o [CAM] tab: Control the camera operation (zoom, focus,auto function, etc.).■ Basic settingsConfigure the minimum required settings to operate the recorder.Click the [Setup] button, and then clickthe [Quick] button.Set the current time and date.Click the [Set] button just below the"Time & date" setting.→ The "Quick" page will be displayed.1. Set the current time2. Register camerasSelect a port to which cameras areconnected to detect them.→ Select the camera port or the clientPC port.Determine how to assign and registeran IP address of the detected camera.→ Select [Register the IP addressautomatically given by this unit to adetected camera] or [Register theIP address set with a detectedcamera].Click the [Registration] button, and thenclick the [OK] button.→ The "Camera registration result"window will be displayed after theregistration is complete.Check the registration results, and thenclick the [OK] button.→ Up to 64 cameras can be registered.• When the desired camera is notdetected or when the settings of acamera are required to bechanged, configure the settings onthe "NW camera" page.3. ProgramWhen the camera registration is com-plete, the recording rate for the liveimage transmission and manual record-ing on the "Program" page will automati-cally be set to "1 ips".Click the [Display] button to check thedetailed settings of "Program".➜ ➜