65Configure the settings relating to NTP/SNMP synchronization[NTP/SNMP]The settings to synchronize the system clock with the NTP (Network Time Protocol) and SNMP (Simple Network ManagementProtocol) server can be configured on this tab.■ NTP setup[Time adjustment]Select "On" or "Off" to determine whether or not to adjustthe time according to the NTP server.On: Adjusts the time automatically.Off: Does not adjust the time automatically.Default: Off[NTP server address]Enter the address or name of the NTP server when adjustingthe time using the NTP server.The name of the NTP server is available only when "Manual"is selected for "DNS" on the [Basic] tab accessed from the"Advanced setup" menu - the "Network" page of the setupmenu.Enter up to 255 alphanumeric characters including hyphens(-) and periods (.).Important:• It is possible to run the recorder as an NTP server to bereferred by the cameras. In this case, set the port num-ber of the camera to "123". Refer to the operatinginstructions of the connected camera for information onhow to configure the settings of the camera.■ SNMP setupSet this item to check the status of the recorder by connect-ing to the SNMP server.Enter the items using the alphanumeric characters listed in“Note" (☞ page 63) and symbols.[Community]Enter a name used for SNMP authentication (up to 32 alpha-numeric characters).[System name]Enter a name (up to 255 alphanumeric characters) for man-agement of the recorder by the SNMP system.Example: No.1[Location]Enter a location name (location where the recorder isinstalled) in alphanumeric characters.Example: 2F[Contact]Enter the contact information such as a mail address of anadministrator of this recorder.
