1 Connection with Digital Disk Recorder WJ-RT416 SeriesNotes:• Consult with service personnel for details on connecting with a recorder to operate via a LAN or the Internet.• Confirm the recorder firmware is Ver. 1.41 or later.• Only one recorder can be connected to the DATA HDR connector of this unit. (Multiple unit connections, such as a cas-cade connection, are not available.) Basic ConnectionThe following describes the connection between a recorder and this unit to confirm the images are arriving from the recorder.1. Set the unit address of the recorder to 1.2. Set the [Camera control] setting to "PSD" for all cam-eras in the recorder SETUP MENU.3. Connect the unit's CAM OUT 1 to 16 connectors tothe recorder's VIDEO IN 1 to 16 connectors with acoaxial cable.4. Connect the unit's EXT IN connector to therecorder's MULTISCREEN OUT connector with acoaxial cable.5. Connect the unit's DATA HDR connector to therecorder's DATA port with a modular cable.Notes:• Make sure that recorder's unit address is set to 1through the SETUP MENU or SX150A administratorConsole. (Refer to this unit's operating instructions.)If another number is selected, you cannot controlthe recorder.• From system controllers connected to the unit (WJ-SX150A), you cannot control monitors connected tothe MONITOR 1 connector of the recorder.SIGNAL GNDPOWERAC INCAMERA1122332DATA 3 DATA 2SERIALALARMTERMOFF ON 42143CAMERASW INRS485(CAMERA)LINESELECTMONITOR OUTEXT IN(PLAY IN)EXT OUT(REC OUT)OUTIN4455667788991010111112121313141415151616RS485(CAMERA)DATA 4DATA HDRPS•DATADATA 1System controller(Terminal Mode)EXT IN MONITOR OUTRecorder*DATA HDRMONITOR 1 DATA* Set the recorder unit address to 1.MonitorAUX INAUDIO OUTINOUT16 15 14 13 12 11 10 9 8 7 6 5 4 35 3 16 4 21214 13 12 11 10 9 8 7 6 5 4 3 2 116 15MONITOR1 MONITOR2RS485(CAMERA)MODE1 2DATA 10/100BASE-T COPY1 ALARM IN/CONTOROL AUDIO IN SIGNAL GNDPOWERONOFFAC INAUDIO IN/ALARM OUTVIDEOSERIALSYSTEM CONNECTIONS AND SETUPS (WJ-RT416 SERIES)Addendum for WJ-RT416 and WJ-SX150 Series