38● Basic SpecificationsPower supply 120 V AC, 60 Hz or 220 V to 240 V AC, 50 Hz*Power consumption 10 WTemperature range 0 °C - +45 °C (32 °F - 113 °F)Dimensions 480 mm (W) x 44 mm (H) x 250 mm (D) [16-15/16” (W) 1-3/4” (D) x 9-7/8”] (when shipped,excluding projections such as knobs)Weight Approx. 3.4 kg (7.5 lbs.)Frequency response 20 Hz to 20 kHz +0 dB/–0.5 dB (stereo input)300 Hz to 20 kHz +0 dB/–0.5 dB (mono input, sensitivity + 60 dBu)High-pass filter 20 Hz to 20 kHz (included in all mono inputs)Total harmonic distortion 0.1 % or less (at mono input)Input conversion noise –126 dB or less (source impedance 150 Ω or less, audio band 22.4 Hz - 22.4 kHz)Residual noise –94 dB or less (status where the knobs of all volumes and fader levels are turned down asfar as possible, audio band 22.4 Hz to 22.4 kHz)Maximum input +12.2 dB or more (stereo input)+10 dB or more (mono input, when microphone is selected)Maximum output +24 dB or more (main output, sub output)Crosstalk –80 dB or less, 1 kHz (between adjacent channels)Common mode rejection ratio 70 dB or more, 1 kHz (mono input, at –60 dB of sensitivity)Maximum voltage gain 11.8 dB or more (stereo input)64 dB or more, 1 kHz (mono input, when microphone is selected)● Input CircuitMono inputs 1 to 4 –60 dBu, 10 kΩ, balanced, mono input, four circuits, XLRStereo inputs 1 to 4 –10 dBV (–7.8 dBu), 10 kΩ, unbalanced, stereo input (L/R), four circuits, pinMulti input (mono) –45 dBu, 10 kΩ, balanced, mono input, one circuit, XLRMulti input (stereo) –10 dBV, (–7.8 dBu), 10 kΩ, unbalanced, stereo input (L/R), one circuit, ø3.5 mm (1/8")stereo mini (front panel)Sub input +4 dBu, 10 kΩ, unbalanced, stereo input (L/R), one circuit, RCA● Output CircuitStereo output +4 dBu, 10 kΩ, electronically balanced, stereo output (L/R), one circuit, TRSMono output +4 dBu, 10 kΩ, electronically balanced, mono output, one circuit, TRSSub output +4 dBu, 10 kΩ, electronically balanced, mono output, one circuit, TRSRecording output –10 dBV, 10 kΩ, unbalanced, stereo output (L/R), one circuit, pin* Power supply is not switchable but conformed to your area.SPECIFICATIONSSTANDARD ACCESSORIESRack mounting screws (M5 x 12) .................... 4 pcs.Rubber feet ...................................................... 4 pcs.Acrylic cover ...................................................... 1 pc.Acrylic cover mounting screws (M3 x 6).......... 2 pcs.Acrylic cover mounting spacers ...................... 2 pcs.Label .................................................................. 1 pc.Operating Instructions (this book) ..................... 1 pc.AC power cord .................................................. 1 pc.Guarantee (U.S.A. and Canada only).................1 pc.