Panasonic WV-BM1410 Operating Instructions Manual

Also see for WVBM1410 - B/W MONITOR: Operating instructions

Contents

-5-ADJUSTMENTPreparations:Make sure that all required connections in the system arecompleted.Turn on the power of this monitor by pressing the PowerOn/Off Switch on the front panel.1. Adjust the brightness by the Bright Control (BRIGHT)and the Contrast Control (CONTRAST) so that theoverall brightness is appropriate and grey tones areresolved.2. If the picture slips to either side, or a series of horizon-tal lines appear, adjust the Horizontal Hold Control(H.HOLD) until the picture is stabilized.3. If the picture rolls up or down, adjust the Vertical HoldControl (V.HOLD) until the picture is stabilized.4. The sub controls, HEIGHT and V. LINEARITY, shouldbe adjusted at the same time to give proper verticalheight consistent with good vertical linearity.Extending the picture height approximately 6 mm(1/4”) beyond the top and bottom edges of the CRTmask is recommended.OPERATIONUnder ScanningPress the Scan Size Selection Switch (SCAN SIZE) once(switch down ;) to set the UNDER position.POWERONOFFBRIGHT CONTRASTH.HOLDV.HOLDNORMALUNDERSCANSIZEincreaseincreaseHEIGHT V. LINPress again (witch up l) to NORMAL position.

/ 10

Related manuals for Panasonic WVBM1410 - B/W MONITOR