1. CAMERA SETUP MENUThis camera utilizes an on-screen user setup menu.• Opening the Setup MenuPress and hold down I(S) for 2 seconds ormore.The CAM SET UP menu appears on the monitoras shown at right.Check the current settings on the menu.• Returning to Previous Menu or PageMove the cursor to RET and press I(S).• Closing the Setup MenuMove the cursor to END in the bottom line, and press I(S) to close the setup menu.Note: If no button is pressed for 6 minutes while a setup menu is being displayed on themonitor screen, it is automatically closed and the mode returns to the normal camerapicture.2. SETUP OPERATIONTo set items on the CAM SET UP menu, use the following buttons.Left Button (I) (L): Moves the cursor to the left. Use this button to select or adjust theparameters of the selected item. The parameter changes eachtime this button is pressed.Right Button (I) (R): Moves the cursor to the right. Use this button to select or adjust theparameters of the selected item. The parameter changes eachtime this button is pressed.Up Button (I) (U): Moves the cursor upwards. Use this button to select an item oradjust the parameters.Down Button (I) (D): Moves the cursor downwards. Use this button to select an item oradjust the parameters.Set Button (I) (S): Executes selections and displays a submenu for an item with themark.• All Reset OperationAll Reset allows you to reset all setup menu items to the factory default settings if you areunsure about the correct settings. Proceed as follows:(1) Make sure that the CAM SET UP menu is not displayed (a camera picture is displayed).(2) While pressing both I(L) and I(R), press I(S) for a few seconds. The messageALL RESET momentarily appears on the monitor screen.This resets all adjustments and parameters to the factory default settings.• Editing the CAM SET UP MenuEnabling/Disabling the editing operationsThe settings are protected from changing when SET UP DISABLE appears on the bottomline in the menu.Move the cursor to SET UP DISABLE and press I(S) to change it to SET UP ENABLE.Editing the settings will be enabled. When editing is finished, return the menu to SET UPDISABLE by the above procedure.Using Menu or Five SwitchesThe DIP switches from SW1 to SW5 canselect the parameters of the allocatedfunctions by their positions while thesefive functions are also included in themenu screen. Depending on which youuse for setting, select DIP SW or MENUon the second bottom line in the menu.Move the cursor to DIP SW and pressI(S) to change it to MEMU. You canchange it from MENU to DIP SW in thesame way.Note: When the setup menu is closed after changing the parameters in the menu, the newvalues are stored in the EEPROM (Electrically Erasable and Programmable Read-OnlyMemory). These values remain valid until new values are stored, even if the power ofthe camera is off.↵** CAM SET UP **CAMERA ID OFFALC ALCSHUTTER ---AGC ON(DNR-H)SENS UP OFFSYNC INTWHITE BAL ATW1MOTION DET OFFDIP SWEND SET UP DISABLE↵↵↵** CAM SET UP **CAMERA ID OFFALC ALCSHUTTER ---AGC ON(DNR-H)SENS UP OFFSYNC INTWHITE BAL ATW1MOTION DET OFFMENUEND SET UP ENABLE↵↵↵SETUP↵↵↵** CAM SET UP **CAMERA ID OFFALC ALCSHUTTER ---AGC ON(DNR-H)SENS UP OFFSYNC INTWHITE BAL ATW1MOTION DET OFFDIP SWEND SET UP DISABLE