Panasonic WV-CW594A Installation Manual

Contents

Panasonic WV-CW594A Installation Manual Manual pdf 15 page image

15■ RS485 Communication Parameters (DIP Switch 1)Configuring DIP Switch 1 as shown below resets communication parameters to their factory default settings. You canthen change the settings as desired.1 2 3 4ON5 6 7 8DIP Switch 1 Setting Description1 2 3 4ON5 6 7 81 2 3 4ON5 6 7 81 2 3 4ON5 6 7 8ON1 2 3 4ON5 6 7 8This setting resets communication parameters to the factory default settings.BAUD RATE : 19 200 bit/s, DATA BIT : 8 bit, PARITY CHECK : NONE, STOP BIT : 1 bitBAUD RATE : 9 600 bit/s, DATA BIT : 8 bit, PARITY CHECK : NONE, STOP BIT : 1 bitBAUD RATE : 4 800 bit/s, DATA BIT : 8 bit, PARITY CHECK : NONE, STOP BIT : 1 bitBAUD RATE : 2 400 bit/s, DATA BIT : 8 bit, PARITY CHECK : NONE, STOP BIT : 1 bitONPerform the following steps to use this setting.(1) Turn off the camera and use DIP Switch 1 to configure RS485 communication parameters as shown above.(2) Turn on the camera.This applies the setting you configured in step (1).(3) Turn off the camera, use DIP Switch 1 to set the unit number (☞ pages 13 and 14), and then turn the cameraback on again.