4SpecificationsAmbient operating temperature: –45 °C to +60 °C {–49 °F to 140 °F}Mass: Approx. 74 g {0.16 lbs}Dimensions: Diameter: 115 mm {4-17/32 inches}Height: 60 mm {2-3/8 inches}Dome radius 42 mm {1-21/32 inches}Standard AccessoriesOperating Instructions (this document).............1 setWaterproof rubber (for replacement) ................1 pc.ClearSight coating label ...................................1 pc.Dome cover fixing screws(without washer, 2 pcs.)Installation auxiliary wireDome cover fixing screw (with washer, 1 pc.)Dome cover holding plateDome coverWaterproof rubberProtrusionEnclosureWasherPrecautions• Due to effectiveness of the rain wash coating, drops are likely to be accumulated right underthe camera and it may cause a partial distortion of the video.• When cleaning the dome cover, hose or spray fresh water that is not containing lubricant agentor silicon substances and wash away adherents such as grain of sand. If dirt is hard to remove,use a sponge soaked into the fresh water mentioned above and wipe off.• Do not wipe the cover with a dry cloth. (Using dry cloth may spread oil constituent adhered tothe surface, and it may result in damaging the rain wash coating.)• If dirt cannot be wiped off with a damp cloth, use a neutral detergent and sufficiently rinse offthe detergent.• Do not use organic solvent such as benzine and thinner.• Before using a spray, abandon a few sprays to eliminate impurities.• The mark of light-shielding parts left inside the dome or dirt on the dorm cover may influencethe reflection of infrared rays.Therefore, remove those marks and dirt using cleaning paper.* Improper cleaning of the dome cover may cause the rain wash coating to become less effective.In this case, in order to have effective rain wash coating, a new dome cover must be purchasedto replace the existing dome cover. Consult with your dealer or construction contractor.