CAMERA INSTALLATION-16-Precautions• Make sure that the place you are installing the camera is strong enough to support it. If it is not strong enough,then the camera may fall and hurt someone.• The following steps of installation and connection work should be done by qualified service personnel orsystem installers and should conform to all local codes.• Be sure to turn the power off before installation and connection.• Do not install the camera near the air outlet of an air conditioner.■ Mounting the CameraWall mountThe figure shows an example of the camera mountedon a wall with the optional WV-Q122 Wall MountBracket. See instructions included with the optionalbracket● Construction● Assemble procedure1. Preparations(1) Procure a ceiling mount bracket.(2) To prevent the camera from falling, use amounting a bracket to which a safety wire canbe attached.(3) Installation SurfaceCaution: Consult an expert on the load bearingcapacity of the installation surface andstructure. If the surface is not strong enough,the camera may fall down. Refer to theproduct specifications for weights.Prepare appropriate hardware (e.g. wall nuts,anchor bolts, etc.) for fixing on the installationsurface.2. Disassembling the Camera(1) Remove the upper base from the camera byloosening 3 screws. The screws that areremoved need to be used during reassembly.Be careful to not lose them. Turn the upper baseand separate it.* Special screw (mounting screw): Use ahexagon wrench for the hexagon screw (M6).(Ø58)(60) 258540 1-1/2A deep 30 MAXPT11 crest (parallel pipe thread)40 1-1/2B deep 30 MAXPT11 crest (taper pipe thread)x3Ceiling mountThe figure shows an example of the camera mountedon a ceiling with a locally procured bracket.Refer to the instructions included with the bracket forfilling gaps and holes with waterproof material.WV-CW960_US 05.11.18 11:08 ページ16