Panasonic WV-SW155 Installation Manual

Also see for WV-SW152: Specifications Specifications Installation guide

Panasonic WV-SW155 Installation Manual Manual pdf 13 page image

13Precautions for installationThis product is designed to be installedunder eaves.Install the product under eaves to avoid directsunlight.Installing placeContact your dealer for assistance if you areunsure of an appropriate place in your particu-lar environment.• Make sure that the installation area isstrong enough to hold this product, suchas a concrete ceiling.• Install the camera in the foundation area ofthe architecture or where sufficientstrength is assured.• If a ceiling board such as plaster board istoo weak to support the total weight, thearea shall be sufficiently reinforced.Do not place this product in the followingplaces:• Locations where a chemical agent is usedsuch as a swimming pool• Locations subject to humidity, dust, steamand oil smoke• Locations where a radiation, an X-ray, astrong radio wave or a strong magneticfield is generated• Locations where corrosive gas is pro-duced, locations where it may be dam-aged by briny air such as seashores• Locations where the temperature is notwithin the specified range (page 38).• Locations subject to vibrations that exceedthe railway specifications (EN50155)• If a ceiling board such as plaster board istoo weak to support the total weight, thearea shall be sufficiently reinforced.Be sure to remove this product if it is notin use.Design and engineer the power supplysystem to turn on/off the power of thisproduct.The product has no power switch. Wheninstalling the product, use a PoE hub equippedwith the ON-OFF switch for servicing.About the network connectionWhen connecting to a network using the net-work cable of this product, observe the follow-ing.• When wiring for the network, design andengineer not to be affected by thunder.• It is impossible to install this product incombination with a pan/tilt head.Screw tightening• The screws and bolts must be tightenedwith an appropriate tightening torqueaccording to the material and strength ofthe installation area.• Do not use an impact driver. Use of animpact driver may damage the screws orcause tightening excessively.• When a screw is tightened, make thescrew at a right angle to the surface. Aftertightening the screws or bolts, performvisual check to ensure tightening is enoughand there is no backlash.Procure fixing screws separately.The screws that secure this product are notsupplied. Prepare them according to the mate-rial and strength of the area where the productis to be installed.Panasonic assumes no responsibility for injuries or property damage resulting from fail-ures arising out of improper installation or operation inconsistent with this documenta-tion.